Optimisation of flywheel energy storage systems with geared transmission for hybrid vehicles

Abstract

Flywheel energy storage devices may be coupled to mechanical transmissions for braking energy recovery and the provision of additional power for acceleration in hybrid vehicles. Power transmission across a continuous range of speed ratios is necessary. The flywheel size and depth-ofdischarge must be chosen for a particular application, and this has a direct effect on transmission efficiency, required gearing ratios and mass of components. Optimisation of these parameters requires a fundamental understanding of this interaction, which has not previously been investigated and reported. To address this, the current paper presents a new method of analysing mechanical flywheel systems. A simple algebraic analysis can be used to specify flywheel system parameters for any regenerative braking application where the flywheel is used to provide initial acceleration of the vehicle from stationary. This has been applied to systems using geared transmissions with continuous speed variation achieved through sliding contact in clutch and brake components. The results of the analysis highlight how the optimum selection of flywheel depth-of-discharge must achieve a balance between high transmission efficiency and low system mass. This is illustrated for a passenger car application, allowing a full assessment of system performance and the specification of appropriate design parameters.

A Novel Energy Recovery System Integrating Flywheel and Flow Regeneration for a Hydraulic Excavator Boom System

“…There are also other cheaper alternatives for continuous variable transmissions, such as using a brake-actuated planetary gear system [51], a fixed ratio gearbox with a slipping clutch [52], or a gearbox with a few steps plus a smaller gearbox [53]. However, this results in a lower energy efficiency than using a continuous variable transmission [54]. In summary, there is a compromise between improving energy efficiency and increasing the total cost which is highly dependent on design.…”

Numerical and Experimental Identification of the Aerodynamic Power Losses of the ISWEC

“…This paper focuses on the Inertial Sea Wave Energy Converter (ISWEC) [13], which is based on a spinning flywheel inside a closed hull: thanks to the gyroscopic effect, the pitching motion of the floater is converted into roll oscillations, and ultimately converted into electrical power by means of an electrical power take-off (PTO). Note that spinning flywheels are also employed in renewable energy plants and in industrial systems as either mechanical energy storage or to smooth the generated power output [14]. Among the main competitive advantages of employing a gyroscopic system for power production, as in the ISWEC, are the high reliability, ease of accessibility and maintenance in loco, and propensity to implement active control strategies [15][16][17].…”

A Multi-Agent System for Smart Energy Management Devoted to Vehicle Applications: Realistic Dynamic Hybrid Electric System Using Hydrogen as a Fuel

“…New zero-emission hybrid electric vehicles are generally classified into several categories and are distinguished according to their energy types such as battery, regenerative braking, flywheel, etc. [4,5]. Their power sources can be a fuel cell, a supercapacitor, a motor, a battery, etc.…”