On the influence of loading profile upon the tensile failure of stainless steel

Abstract

A material placed in direct contact with a high explosive experiences a Taylor wave (triangular-shaped) shock loading profile. While a large number of studies have probed the structure, properties, and tensile response of materials subjected to square-topped shock loading pulses histories, few studies have systematically quantified the influence of shock-wave profile shape on material response. Samples of 316L stainless steel were shock loaded to peak stresses of 6.6, 10.2, and 14.5 GPa to examine the influence of square-topped and triangular (Taylor wave)-shaped pulse loading on the dynamic tensile behavior (spallation). The 316L SS samples were loaded with a square-topped pulse to each peak shock stress, using a pulse duration of 0.9 μs. They displayed increasing incipient spallation damage with increasing peak stress. Samples loaded to the peak shock stresses of 6.6 and 10.2 GPa with a Taylor-wave loading pulse (which immediately unloads the sample after the peak Hugoniot stress is achieved) exhibited no damage. Only the 14.5 GPa Taylor pulse shocked sample exhibited both a pull-back signal and incipient damage following tensile loading. The damage evolution in the square-topped shocked samples was found to be a mixture of void and strain localization damage, the void fraction increasing with peak shock amplitude. With the Taylor-wave loading profile of amplitude 14.5 GPa, a high incidence of shear localization and low incidence of void formation was observed. Detailed analysis of the damage evolution as a function of shock pulse shape revealed that a nominally equivalent level of incipient damage was obtained using a Taylor-wave or square-topped loading pulse when a similar rear sample surface stress-time total impulse was applied. In order to induce equivalent damage with the two pulse shapes, the impulse applied needed to be nominally matched. For this to occur, the Taylor-wave profile required twice the amplitude of the square one and the durations of each pulse needed to be appropriately scaled. Detailed metallographic, microtextural, and void shape and size analyses of the damage evolution are presented as a function of the inferred loading pulse shape and the peak Hugoniot stress.

Structure/property (constitutive and dynamic strength/damage) characterization of additively manufactured 316L SS

“…Regions of coalesced voids linked by a network of shear localized plastic flow regions were observed. This mode of damage evolution in 316L SS is similar to that observed previously on wrought 316L SS [22,23]. Higher magnification imaging of the ductile voids show that most of the voids are associated with grain boundaries suggesting that boundaries are the primary void nucleation sites similar to past observations in pure copper [24].…”

Influence of shockwave profile on ejection of micron-scale material from shocked Sn surfaces: An experimental study

“…or distribution of ejecta. Recent work in the shock compression field, however, links the shock-pulse's shape to the amount, and type, of material damage within bulk shocked material [8][9]. These results imply creation of ejecta, which is also a damage process, may be related to the shock loading profile.…”

Influence of sweeping detonation-wave loading on shock hardening and damage evolution during spallation loading in tantalum

“…Over the past five decades numerous studies have provided a wealth of experimental data and insight concerning shock hardening and the spallation response of materials subjected to square-topped shock-wave loading profiles [1][2][3]. Fewer researchers have quantified the effect of direct, in-contact, high explosive (HE)-driven Taylor wave (or triangular-wave) loading on the shock hardening, damage evolution, or spallation response of materials [4,5].…”