Numerical Simulation and Flame Analysis of Combustion and Knock in a DISI Optically Accessible Research Engine

Abstract

The increasing limitations in engine emissions and fuel consumption have led researchers to the need to accurately predict combustion and related events in gasoline engines. In particular, knock is one of the most limiting factors for modern SI units, severely hindering thermal efficiency improvements. Modern CFD simulations are becoming an affordable instrument to support experimental practice from the early design to the detailed calibration stage. To this aim, combustion and knock models in RANS formalism provide good time-to-solution trade-off allowing to simulate mean flame front propagation and flame brush geometry, as well as “ensemble average” knock tendency in end-gases. Still, the level of confidence in the use of CFD tools strongly relies on the possibility to validate models and methodologies against experimental measurements.In the paper, two sets of cycle-resolved flame visualizations are available from a single-cylinder 400 cm3 direct-injection spark-ignition (DISI) unit with optical access. The engine is operated at two spark timings, ranging from knock-safe to light-knock conditions.On this basis, a numerical analysis is carried out to reproduce flame kernel growth and propagation using the well-known ECFM-3Z combustion model for all the operating conditions. CFD results are compared in terms of enflamed volume and flame morphology against cycle averaged experimental data. In addition, average knock is simulated by means of the in-house built UniMORE Knock Model [1] in terms of knock onset location and phasing.The agreement between predicted and measured position of the flame front and knock inception location for the two different operating conditions confirms the validity of the adopted models and proves their predictive capability for engine design and optimizatio

Flame Front and Burned Gas Characteristics for Different Split Injection Ratios and Phasing in an Optical GDI Engine

“…On the other hand, this type of test bed provides valuable information in terms of in-cylinder phenomena. Therefore, it has been used by many researchers and companies in recent years [1,32,33]. One other issue is that the optical window is flat, while the setup found in the commercial engine from which the cylinder head was taken featured a profile designed for wall guided stratification (i.e.…”

CFD Analysis and Knock Prediction into Crevices of Piston to Liner Fireland of an High Performance ICE

“…Vancoillie et al [42] used a fuel-specific Arrhenius formulation for the reaction rate of methanol and ethanol and the average ignition delay was used to integrate a knock precursor species. A similar approach based on the calculation of fuel specific AI delays from chemical kinetics simulations with validated mechanism was developed and used in the past by d'Adamo et al in a research unit in [43]. Chen and co-authors investigated the influence of turbulence intensity on the knock propensity of a highly downsized SI engine in [44].…”

Experimental study of spatial distribution of knock events in a turbocharged spark-ignition engine

“…The experimental results also showed that several knock events occurred on the exhaust side. Iaccarino et al 18 observed on a single-cylinder optical engine that the auto-ignition combustion occurred on both sides of the cylinder. The statistical results showed that the knock probability on the intake side was relatively high and that on the exhaust side was relatively low.…”