Moulded polypropylene foams produced using chemical or physical blowing agents: structure–properties relationship

Abstract

Polypropylene (PP) foams have become\ud essential items due to their excellent properties. Nevertheless,\ud obtaining net-shaped PP foams with medium relative\ud densities is a complicated issue. In this article, two\ud processes able to produce moulded PP foams in this density\ud range are presented. One of them is based on a modification\ud of the pressure quench foaming method and therefore\ud uses a physical blowing agent (CO2). The second one is the\ud improved compression moulding technique which uses a\ud chemical blowing agent (azodicarbonamide). PP foams\ud with relative densities in the range between 0.25 and 0.6\ud and cylindrical shape were prepared using these foaming\ud techniques. A common PP grade (instead a highly branched\ud one) was used to obtain the samples, showing, that by\ud combining the appropriate foaming technique, the adequate\ud moulds, suitable blowing agent and proper foaming\ud parameters, net-shaped PP foams with excellent properties\ud can be produced starting from a conventional PP grade.\ud Samples were characterized by analyzing their cellular\ud structure and their mechanical properties. Results have\ud showed that depending on the chosen foaming route isotropic\ud or anisotropic structures with cell sizes ranging from 40 to 350 lm and open cell content in the range between 0\ud and 65% can be obtained. Moreover, mechanical properties\ud are highly influenced by the production route and chemical\ud composition of the foams. For instance, the stiffer materials\ud at relative densities higher than 0.4 are the ones produced\ud using the chemical blowing agent while at relative densities\ud lower than 0.4 are the ones produced using the physical\ud blowing agent.Peer ReviewedPostprint (published version

Sub-mm sized bubbles injected into metallic melts

“…New application fields such as electrodes for batteries, catalysis or micro foamed pieces are possible applications of microcellular metal foams. This would correspond to the current trend in polymer foam development [42,43].…”

Low density polyethylene/silica nanocomposite foams. Relationship between chemical composition, particle dispersion, cellular structure and physical properties

“…In this modified process the solid precursors were foamed inside a cylindrical mold. The objective of preparing the foams in a mold is to produce foams with similar densities and controlled geometries [26]. A nominal expansion ratio (that is, density of the solid nanocomposite divided by the density of the foamed material) of 1.6 was fixed for all the foamed samples.…”

Strategy for the preparation of lightweight polypropylene/polyethylene‐octene elastomer composite foams with different phase morphologies using supercritical carbon dioxide

“…[1][2][3][4][5][6] Because automotive parts require lightweight materials, PP must be lightweight. [11][12][13][14][15][16][17] Chemical foaming agents and physical foaming agents are the most popular foaming agents for the preparation of PP microcellular foaming materials. [11][12][13][14][15][16][17] Chemical foaming agents and physical foaming agents are the most popular foaming agents for the preparation of PP microcellular foaming materials.…”