Modeling and Control of a Large-Stroke Electrothermal MEMS Mirror for Fourier Transform Microspectrometers

Abstract

A microelectromechanical systems (MEMS) mirror with large vertical displacement has been developed for Fourier transform microspectrometers, but there exists a large tilting during the large-stroke scanning of the MEMS mirror, which greatly compromises the usable range. In this paper, a closed-loop control method has been established to minimize the tilting of the MEMS mirror. According to experimental results, the tilting motion of the mirror plate can be modeled as a fourth-order system. A feedback controller consisting of a phase-lag compensator, a low-pass filter and a notch filter utilized to stabilize the closed-loop tilt system. A gain scheduling approach is also used to compensate the bias-dependent loop gain and thereby provide more consistent tilting rejection over a wide scan range. Compared with the open-loop drive approach, the closed-loop system offers a stable scan operation with much faster dynamic response and improved overall robustness. The experiments show that the residual tilting is reduced to below ±0.0015°during the full range scan of the MEMS mirror. With this control method, the MEMS mirror achieved a stable scan range up to 356.4 µm, so the measured spectral resolution reached 28 nm at 532 nm in a microspectrometer. The mirror tilting can be reduced dramatically by the proposed active control scheme, and thereby, the usable vertical scan range is increased significantly.[2016-0061]

A Compound Control System for FR4-Based Electromagnetic Scanning Micrograting

“…In recent years, most of the scanning micrograting has been developed and fabricated using MEMS technology. The actuation mechanisms can be mainly divided into four categories: electrostatic [9], electrothermal [10,11], electromagnetic [12][13][14][15], and piezoelectric [16]. The electromagnetic actuation mechanism is widely used for its large driving torque, linear mechanical properties, and low driving voltage.…”

Investigation of Electromagnetic Angle Sensor Integrated in FR4-Based Scanning Micromirror

“…External optical sensors may be a good solution to provide a real-time feedback signal [4,16,17]. However, this requires a complex assembly, and inevitably increases the system's volume and cost.…”

The Designing of Magnetic-Driven Micromirror for Portable FTIRs

“…Drabe et al [12], Ataman et al [13], and Ferhanoglu et al [14] have used resonant inplane comb drives. Wang et al [15,16] and Han et al [17] are based on nonresonant electrothermal actuation. These translatory MOEMS devices could be used for instance to adjust an optical path length/optical path difference, something which is of interest for a range of applications, including confocal microscopy, optical coherence tomography, and also for FTIR spectroscopy.…”