Mixing and Entrainment Characteristics of Circular and Noncircular Confined Jets

Abstract

The present work deals with the experimental investigation of entrainment characteristics of confined/semiconfined circular and noncircular jets. The jet fluid, after issuing out of a nozzle of circular or noncircular cross section, enters a circular mixing tube of larger area, and during this process it entrains some ambient fluid into the mixing tube. The flow is incompressible and isothermal at a jet Reynolds number of 7200. The experimental results obtained in the study are first validated with the approximate theoretical analysis of Pritchard et al. (1997) and also with the similarity solution proposed by Becker et al. (1963) for circular nozzles. It is observed that the similarity solution is applicable for circular as well as noncircular jets in the region close to the jet axis and away from the nozzle exit plane. The entrainment ratio increases to a maximum value as the jet location is shifted away from the tube inlet; for the configurations studied, enhancement up to 30% has been observed in the entrainment ratio with shift in jet location. For a smaller mixing tube diameter and jet located at the inlet of the mixing tube, the circular jet entrains more than noncircular jets. For a larger mixing tube or shifted jet locations, the noncircular jets entrain more of ambient fluid, in general. Among the different noncircular geometries considered, the jet having the cross section of an isosceles triangle causes maximum entrainment.

Prediction of entrance length and mass suction rate for a cylindrical sucking funnel

“…Figure 3(a) also shows the grid arrangement that was used to compute the mass suction. A comparison between Q suc /Q inlet with that of the experiment of Singh et al [5] and Pritchard's relation for the confined jet can be seen from Figure 3(a). The present CFD result matches well with the analytical solution developed by Pritchard et al [6] and also reasonably well with that of the experiment.…”

Effect of jet angle and orifice shape in gas–gas mixer using CFD

“…This optimum angle was likely to change with the velocity ratio. Singh et al (2003) have investigated the entrainment characteristics of confined and semi-confined circular and noncircular air jets (axial jet) experimentally. They have investigated nozzles of different shapes (ellipse, isosceles triangle, rectangle and square) having equal flow cross-sectional area.…”

Enhancement of turbulent scalar mixing and its application by a multihole nozzle in selective catalytic reduction of NOx

“…[3][4][5] Specifi cally, the characteristics of jet or plume fl ows issuing into an ambient fl ow at a slanting angle have been widely studied. [6][7][8] In such cases, a vortical motion appearing in the fl ow could increase the scalar mixing between the two fl uid streams.…”