Microstructures and Properties of NbC-Reinforced Ni-Based Coatings Synthesized In Situ by Ultrasonic Vibration-Assisted Laser Cladding

Abstract

This paper aims to explore the mechanism of an ultrasonic applied field on the microstructures and properties of coatings, and clarify the evolution of the molten pool under different ultrasonic frequencies. The Taguchi experimental design method was adopted in this paper. NbC-reinforced Ni-based coatings were in situ synthesized by laser cladding to investigate the effects of ultrasonic vibration process parameters on the microstructure, pore area, microhardness, and wear resistance of the cladding layer. The results show that the pore area decreases first and then increases as ultrasonic power increases from 600 to 900 W and ultrasonic frequency from 23 to 40 kHz. On the contrary, the hardness and wear resistance increase at first and then decrease. The pore area is minimized at 800 W ultrasonic power and 32 kHz ultrasonic frequency, and the hardness is maximized at 600 W ultrasonic power and 40 kHz ultrasonic frequency. Meanwhile, the highest wear resistance can be obtained when ultrasonic power is 700 W and ultrasonic frequency is 32 kHz. Based on the phase structure analysis, the cladding layer mainly consists of FeNi3, NbC, B4C, and CrB2. Ultrasonic vibration will not change the phase composition of the layer. Combined with the varying G/R value and cooling rate, the reasons for the change in grain morphology in different areas were analyzed to reveal the evolution mechanism of the molten pool under the influence of ultrasound.

Wear Resistance of In Situ NbC-Reinforced Laser Cladding Ni45 Coatings

“…They have the advantages of high bond strengths, small heat-affected zones, high microhardnesses, and good wear resistance. Nickel-based NbC composite coatings are widely used in the surface strengthening and repair of automotive molds, engine turbines, and combustion turbine blades due to their high microhardness and good wear resistance [11][12][13][14][15].…”