Microstructure, bonding strength, and friction–wear performance of AlCrN/nitrided layer composite coating on H13 hot work mould steel

Abstract

An AlCrN/nitrided layer (NL) composite coating was fabricated on H13 hot work mould steel using a cathode arc ion plating and low temperature plasma nitriding. The surface and cross‐section morphologies, chemical composition, phases, and roughness of AlCrN/NL coating were analyzed using a scanning electron microscope (SEM), energy dispersive spectrometer, X–ray diffractometer (XRD), and atomic force microscope, respectively, the friction–wear performances of AlCrN/NL coatings at 400, 500, and 600°C were investigated using a high‐temperature wear test. The results show that the AlCrN/NL coating with the surface roughness of 76.8 nm forms the AlN phase, which increase its hardness from 1088 HV of NL to 2381 HV. The average coefficients of friction (COFs) of AlCrN/NL coating at 400, 500, and 600°C are 0.70, 0.55, and 0.56, respectively, and the corresponding wear rates are 1.59 × 10−5, 9.77 × 10−5, and 3.93 × 10−5 mm3/N/m, respectively, as a result, the lowest average COF and wear rate are at 500 and 400°C respectively. The wear mechanism of AlCrN/NL coating at 400°C is primary abrasive wear, accompanied by adhesive wear, while those at 500 and 600°C are primary adhesive wear, accompanied by abrasive wear.