Mapping of the Samara city by definition of areas with hydrogen degassing using Raman spectroscopy

Timchenko, E. V.; Тимченко, П. Е.; Taskina, L. A.; Тregub, N. V.; Селезнева, Е. А.

doi:10.1117/12.2179510

Cited by 5 publications

(2 citation statements)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…PhIO-2018 In the course of the research, a series of test experiments to study the non-invasive effects and optimal plant parameters was first used, the laser power from 50 to 500 mW was used. A change in the height of the probe over the object in the interval 6-8 mm exerted an insignificant influence on the values of the ratio of Raman scattering lines (the error value did not exceed 7%) [11]. PhIO-2018 Of greatest interest in the analysis of Raman spectra are the lines at wave 835 cm −1 (Tyrosine), 1240 cm −1 (amide III), 1660 cm −1 (amide I).…”

Section: Kne Energy and Physicsmentioning

confidence: 99%

The application of the Raman Spectroscopy Method for Evaluating Implants from the Dura Mater

Тимченко¹,

Timchenko²,

Волова³

et al. 2018

KEn

View full text Add to dashboard Cite

The results of a comparative spectral evaluation of the component composition of the surfaces of implants from the dura mater manufactured using the Lioplast technology with the use of ultrasound and sterilization are presented. Based on the analysis, coefficients were introduced reflecting the change in the relative concentration of components that determine the quality of the implants. It is established that Raman spectroscopy can be used to assess the change in the composition of implants based on the dura mater during their manufacture.

show abstract

Section: Kne Energy and Physicsmentioning

confidence: 99%

The application of the Raman Spectroscopy Method for Evaluating Implants from the Dura Mater

Тимченко¹,

Timchenko²,

Волова³

et al. 2018

KEn

View full text Add to dashboard Cite

show abstract

“…The method includes a high-resolution digital spectrometer Shamrock sr-303i with a spectral range of 200-1200 nm, with a built-in cooled camera DV420A-OE, a fiber-optic probe RPB-785 for Raman spectroscopy, combined with a LuxxMaster LML-785.0RB-04 laser module with a length a wave of laser radiation of 785 nm and a line width of 0.2 nm [11,12].…”

Section: Materials and Methods Of Researchmentioning

confidence: 99%

Analysis of Synovial Fluid for Study of Diseases of Joints Using the Method of Raman Spectroscopy

Тимченко¹,

Timchenko²,

Волова³

et al. 2018

KEn

View full text Add to dashboard Cite

This paper presents the results of experimental studies using the synovial fluid Raman spectroscopy method, which was obtained from the joint cavity during the operation. By analyzing the composition of the synovial fluid, it was found that with the development of the degenerative-dystrophic process in the synovial fluid of the affected joint, the total number of components at wave numbers: 1155 cm-1 (Hyaluronic acid (C-O, C-C)) and 1250 cm-1 (Amide III). The introduced optical coefficients allow estimating the synovial fluid in osteoarthritis and further this method of Raman spectroscopy can become a new diagnostic screening for the detection of articular pathology.

show abstract

Optical method for assessing the effectiveness of treatment of staphylococcal infection of tonsils

Тимченко

Timchenko

Asadova

et al. 2018

J. Phys.: Conf. Ser.

View full text Add to dashboard Cite

Mapping of the Samara city by definition of areas with hydrogen degassing using Raman spectroscopy

Cited by 5 publications

References 7 publications

The application of the Raman Spectroscopy Method for Evaluating Implants from the Dura Mater

The application of the Raman Spectroscopy Method for Evaluating Implants from the Dura Mater

Analysis of Synovial Fluid for Study of Diseases of Joints Using the Method of Raman Spectroscopy

Optical method for assessing the effectiveness of treatment of staphylococcal infection of tonsils

Contact Info

Product

Resources

About