Magnetic annealing of extruded thermoplastic magnetic elastomers for 3D-Printing via FDM

Fischer, Nathan A.; Robinson, Alex Lockwood; Lee, Thomas J.; Calascione, Thomas M.; Koerner, Lucas J.; Nelson-Cheeseman, Brittany B.

doi:10.1016/j.jmmm.2022.169266

Cited by 11 publications

(1 citation statement)

References 13 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…FDM printer was used to print all samples due to its capability in printing thermoplastic with good surface quality and mechanical properties [29,30]. Also, printing composite materials can be achieved using this technique [31][32][33]. The open-source FDM printer was used to print the samples as shown in Fig.…”

Section: Fdm Modifications and Printing Parametersmentioning

confidence: 99%

Simultaneous FDM 4D printing and magnetizing of iron-filled polylactic acid polymers

Moradi

Dezaki

Kheyri

et al. 2023

Journal of Magnetism and Magnetic Materials

View full text Add to dashboard Cite

Section: Fdm Modifications and Printing Parametersmentioning

confidence: 99%

Simultaneous FDM 4D printing and magnetizing of iron-filled polylactic acid polymers

Moradi

Dezaki

Kheyri

et al. 2023

Journal of Magnetism and Magnetic Materials

View full text Add to dashboard Cite

Additive Manufacturing of Composite Materials and Functionally Graded Structures Using Archerfish Hunting Technique

Prakash,

Koushik,

Jha

et al. 2024

Lubrication Science

View full text Add to dashboard Cite

This paper proposes an optimisation method for fabricating composite materials and functionally graded structures. Using the proposed method, 3D printing of copper (Cu)–polyethylene (PE) composite, Al2O3–ZrO2 ceramic composite and functionally graded CuO foams are utilised. This work aims to advance the capabilities of additive manufacturing by leveraging nature‐inspired approaches to create complex, tailored structures with enhanced performance across various industries. The major objective of the proposed method is to reduce the feed rate and increase the airflow rate and airflow temperature for the heat transfer process. Using the proposed technique in the advanced preparation conditions, Cu–PE composites with unreliable Cu substances are fabricated. The PE binder particle is melting as well as forming thick composites by means of soft surfaces. Using the proposed AHO approach, functionally graded materials with common distributions can be efficiently optimised. By then, the proposed model is implemented on the MATLAB platform, and its execution is calculated using the current procedures. The proposed technique displays superior outcomes in all existing methods like wild horse optimiser, particle swarm optimisation and heap‐based optimiser. The proposed method shows a throughput of 57 mm3. The existing method shows the throughput of 32, 27 and 45 mm3. The results show that the proposed method has higher throughput compared with existing methods.

show abstract

A review on fused deposition modeling materials with analysis of key process parameters influence on mechanical properties

Tientcheu,

Djouda,

Bouaziz

et al. 2023

Int J Adv Manuf Technol

View full text Add to dashboard Cite

Magnetic annealing of extruded thermoplastic magnetic elastomers for 3D-Printing via FDM

Cited by 11 publications

References 13 publications

Simultaneous FDM 4D printing and magnetizing of iron-filled polylactic acid polymers

Simultaneous FDM 4D printing and magnetizing of iron-filled polylactic acid polymers

Additive Manufacturing of Composite Materials and Functionally Graded Structures Using Archerfish Hunting Technique

A review on fused deposition modeling materials with analysis of key process parameters influence on mechanical properties

Contact Info

Product

Resources

About