Lignocellulose-derived porous phosphorus-doped carbon as advanced electrode for supercapacitors

Yi, Jianan; Qing, Yan; Wu, Chutian; Zeng, Yinxiang; Wu, Yiqiang; Lu, Xihong; Tong, Yexiang

doi:10.1016/j.jpowsour.2017.03.036

Cited by 243 publications

(89 citation statements)

References 49 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…As for electrode materials, hydrophilicity is important for providing an efficient access for ions to the electrode/electrolyte interface . Water contact angle measurement is performed in Figure S5 (Supporting Information).…”

Section: Resultsmentioning

confidence: 99%

See 1 more Smart Citation

Hierarchical 3D All‐Carbon Composite Structure Modified with N‐Doped Graphene Quantum Dots for High‐Performance Flexible Supercapacitors

Liu

Wang

et al. 2018

Small

109

View full text Add to dashboard Cite

Flexible supercapacitors have shown enormous potential for portable electronic devices. Herein, hierarchical 3D all-carbon electrode materials are prepared by assembling N-doped graphene quantum dots (N-GQDs) on carbonized MOF materials (cZIF-8) interweaved with carbon nanotubes (CNTs) for flexible all-solid-state supercapacitors. In this ternary electrode, cZIF-8 provides a large accessible surface area, CNTs act as the electrical conductive network, and N-GQDs serve as highly pseudocapactive materials. Due to the synergistic effect and hierarchical assembly of these components, N-GQD@cZIF-8/CNT electrodes exhibit a high specific capacitance of 540 F g at 0.5 A g in a 1 m H SO electrolyte and excellent cycle stability with 90.9% capacity retention over 8000 cycles. The assembled supercapacitor possesses an energy density of 18.75 Wh kg with a power density of 108.7 W kg . Meanwhile, three supercapacitors connected in series can power light-emitting diodes for 20 min. All-solid-state N-GQD@cZIF-8/CNT flexible supercapacitor exhibits an energy density of 14 Wh kg with a power density of 89.3 W kg , while the capacitance retention after 5000 cycles reaches 82%. This work provides an effective way to construct novel electrode materials with high energy storage density as well as good cycling performance and power density for high-performance energy storage devices via the rational design.

show abstract

Section: Resultsmentioning

confidence: 99%

“…Carbon‐based supercapacitors have greatly attracted attention due to the large surface area, excellent conductivity, wide pore size distribution, and high cycle stability of carbon electrode materials . Main carbon electrode materials include 1D carbon nanotubes (CNTs), carbon fibers (CFs), 2D graphene, and 3D mes‐carbon .…”

Section: Introductionmentioning

confidence: 99%

Hierarchical 3D All‐Carbon Composite Structure Modified with N‐Doped Graphene Quantum Dots for High‐Performance Flexible Supercapacitors

Liu

Wang

et al. 2018

Small

109

View full text Add to dashboard Cite

show abstract

“…Yi et al [144] prepared a P-doped biomass-derived carbon through the pyrolysis of lignocellulose immersed in ZnCl 2 /NaH 2 PO 4 aqueous solution. Phosphorus with high electron-donating ability is anticipated to remarkably enhance the charge storage and transport capability.…”

Section: Surface Chemistrymentioning

confidence: 99%

Biomass-derived carbon materials with structural diversities and their applications in energy storage

2017

View full text Add to dashboard Cite

Currently, carbon materials, such as graphene, carbon nanotubes, activated carbon, porous carbon, have been successfully applied in energy storage area by taking advantage of their structural and functional diversity. However, the development of advanced science and technology has spurred demands for green and sustainable energy storage materials. Biomass-derived carbon, as a type of electrode materials, has attracted much attention because of its structural diversities, adjustable physical/chemical properties, environmental friendliness and considerable economic value. Because the nature contributes the biomass with bizarre microstructures, the biomass-derived carbon materials also show naturally structural diversities, such as 0D spherical, 1D fibrous, 2D lamellar and 3D spatial structures. In this review, the structure design of biomass-derived carbon materials for energy storage is presented. The effects of structural diversity, porosity and surface heteroatom doping of biomass-derived carbon materials in supercapacitors, lithium-ion batteries and sodium-ion batteries are discussed in detail. In addition, the new trends and challenges in biomass-derived carbon materials have also been proposed for further rational design of biomass-derived carbon materials for energy storage.

show abstract

“…Various precursors with different heteroelement species [15][16][17][18] or increased amount of heteroatoms [4,9,10,[19][20][21][22] including N [20,[23][24][25], P [4,[15][16][17][18][26][27][28][29][30], S [31][32][33][34], Si [9,21,22], and Sn-doping [7,35,36] have been explored to upgrade the carbonaceous anodic materials for Li + ion storage due to their great high theoretical specific capacity of Li + ion storage. Although boron could effectively adjust the lattice defect related to the structure disorder of carbon materials, there are quite few reports on boron-doped carbon as Li + ion storage anode [37].…”

Section: Introductionmentioning

confidence: 99%

Boron-Doped Carbon Nano-/Microballs from Orthoboric Acid-Starch: Preparation, Characterization, and Lithium Ion Storage Properties

Chen

2018

Journal of Nanomaterials

View full text Add to dashboard Cite

A boron-doped carbon nano-/microballs (BC) was successfully obtained via a two-step procedure including hydrothermal reaction (180 ∘ C) and carbonization (800 ∘ C) with cheap starch and H 3 BO 3 as the carbon and boron source. As a new kind of boron-doped carbon, BC contained 2.03 at% B-content and presented the morphology as almost perfect nano-/microballs with different sizes ranging from 500 nm to 5 m. Besides that, due to the electron deficient boron, BC was explored as anode material and presented good lithium storage performance. At a current density of 0.2 C, the first reversible specific discharge capacity of BC electrode reached as high as 964.2 mAh g -1 and kept at 699 mAh g -1 till the 11th cycle. BC also exhibited good cycle ability with a specific capacity of 356 mAh g -1 after 79 cycles at a current density of 0.5 C. This work proved to be an effective approach for boron-doped carbon nanostructures which has potential usage for lithium storage material.

show abstract

Lignocellulose-derived porous phosphorus-doped carbon as advanced electrode for supercapacitors

Cited by 243 publications

References 49 publications

Hierarchical 3D All‐Carbon Composite Structure Modified with N‐Doped Graphene Quantum Dots for High‐Performance Flexible Supercapacitors

Hierarchical 3D All‐Carbon Composite Structure Modified with N‐Doped Graphene Quantum Dots for High‐Performance Flexible Supercapacitors

Biomass-derived carbon materials with structural diversities and their applications in energy storage

Boron-Doped Carbon Nano-/Microballs from Orthoboric Acid-Starch: Preparation, Characterization, and Lithium Ion Storage Properties

Contact Info

Product

Resources

About