Laboratory assessment of the effect of white layers on wear resistance for digger teeth

Xu, Liqun; Clough, Stuart; Howard, P. J.; StJohn, David H.

doi:10.1016/0043-1648(95)90015-2

Cited by 4 publications

(1 citation statement)

References 14 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…White-etching layers were found on the surfaces of all three microstructures studied, in contradiction of work presented in [33] where dry sand abrasion tests at 130 N load failed to produce such layers. Fig.…”

Section: Sub-surface Characterisationcontrasting

confidence: 50%

Three-body abrasive wear of fine pearlite, nanostructured bainite and martensite

Bakshi¹,

Shipway²,

Bhadeshia³

2013

Wear

120

View full text Add to dashboard Cite

The abrasive wear of three metallurgical structures with radically different hardnesses have been investigated for the same steel. The particular steel concerned is a recent innovation capable of generating extremely fine distributions of crystals. The austenite in the alloy nevertheless has the capability of uniformly transforming into extremely fine pearlite, nanostructured bainite, and plate martensite. It is found that although the abrasion rates and wear coefficients are not very different for the three states, the mechanisms of abrasion are quite different. We report detailed characterisation experiments together with comparisons with commercially available steels subjected to identical tests.

show abstract

Section: Sub-surface Characterisationcontrasting

confidence: 50%

Three-body abrasive wear of fine pearlite, nanostructured bainite and martensite

Bakshi¹,

Shipway²,

Bhadeshia³

2013

Wear

120

View full text Add to dashboard Cite

show abstract

Sub-zero treatments of AISI D2 steel: Part II. Wear behavior

Das

Dutta

Ray

2010

Materials Science and Engineering: A

108

View full text Add to dashboard Cite

A Novel Method for the Measurement of Slight Wear

Yang

Jian

Rong

et al. 2013

AMR

View full text Add to dashboard Cite

The characterization of surface wear resistance of materials usually relies on the measurement of slight wear. There are two obvious shortcomings for weighing method. In order to improve the measurement accuracy, a more intuitive and reliable method for quantitative measurement of slight wear, interference microscope method, has be given. Higher accuracy (the order of micrometer) can be achieved using the interferometry for the measurement of slight wear. The results show that the masking processing technology can ensure that all samples for wear testing and other analysis are obtained under the same pretreatment conditions and vacuum processing conditions, speed up the commercialization of processing technology, and comparing the cross-sectional areas of wear scars is a correct way to characterize the wear resistance of different zones.

show abstract

Laboratory assessment of the effect of white layers on wear resistance for digger teeth

Cited by 4 publications

References 14 publications

Three-body abrasive wear of fine pearlite, nanostructured bainite and martensite

Three-body abrasive wear of fine pearlite, nanostructured bainite and martensite

Sub-zero treatments of AISI D2 steel: Part II. Wear behavior

A Novel Method for the Measurement of Slight Wear

Contact Info

Product

Resources

About