Justification of Keyed Joint Fits

Leonov, O. A.; Shkaruba, N. Zh.; Vergazova, Yu. G.; Khasyanova, D. U.

doi:10.3103/s1052618822060073

Cited by 10 publications

(1 citation statement)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The service life of joints can be increased in two ways -by increasing the wear resistance of friction pairs and by rationally choosing the accuracy of parts [1,2]. This is especially true for critical connections of machine units, which are loaded and tend to wear out quickly [3][4][5]. Otherwise, there is an increase in economic losses due to equipment breakdowns and downtime [6], which is not beneficial for the enterprise operating this equipment, and it will choose other brands in the future.…”

Section: Introductionmentioning

confidence: 99%

Justification of the method of surface plastic deformation to strengthen the surface of the shaft under the cuff during repair

Nesterkin,

Konkin,

Golinitsky

et al. 2023

E3S Web of Conf.

View full text Add to dashboard Cite

The shaft-seal connection is a critical element of any unit, and its reliability is important to ensure the service life of the entire assembly unit. Treatment by surface plastic deformation makes it possible to provide hardening to a depth of up to 2 mm, microhardness increases on average by 150% relative to the initial value, and reaches a value of 6500 MPa. Residual stresses after SPD always have a negative value, the depth of their distribution exceeds the depth of distribution of increased microhardness by 1.5 times, which makes it possible to increase the service life.

show abstract

Section: Introductionmentioning

confidence: 99%

Justification of the method of surface plastic deformation to strengthen the surface of the shaft under the cuff during repair

Nesterkin,

Konkin,

Golinitsky

et al. 2023

E3S Web of Conf.

View full text Add to dashboard Cite

show abstract

Experimental Studies on the Form Error Effect of the Part Mounting Surface on the Strength Quality Parameter of the Interference Fit Joints

Kupriyanov,

Trishch,

Dichev

et al. 2023

Lecture Notes in Mechanical Engineering

View full text Add to dashboard Cite

Justification of the type of fit depending on the type of loading and radial clearance in rolling bearings

et al. 2023

View full text Add to dashboard Cite

The main cause of failures occurring during the operation of machines is the failure of bearings, the failure of even one lead to the loss of performance of the entire mechanism. The most common are rolling bearings, which have the following advantages: provide more accurate centering of the shaft; have a lower coefficient of friction; have small axial dimensions. One of the most significant factors determining the durability of a bearing is the value of the radial clearance formed in the bearing in its operating condition, which in the same bearings can change dramatically depending on the conditions of their assembly, the fit of the rings on the shaft and in the housing, as well as on the magnitude of the workload. This clearance has a significant effect on the distribution of the load acting on the bearing between its rolling elements, so it is very important to make the right choice already at the design stage.

show abstract

Justification of Keyed Joint Fits

Cited by 10 publications

References 10 publications

Justification of the method of surface plastic deformation to strengthen the surface of the shaft under the cuff during repair

Justification of the method of surface plastic deformation to strengthen the surface of the shaft under the cuff during repair

Experimental Studies on the Form Error Effect of the Part Mounting Surface on the Strength Quality Parameter of the Interference Fit Joints

Justification of the type of fit depending on the type of loading and radial clearance in rolling bearings

Contact Info

Product

Resources

About