Investigating the diameter of solid particles effects on a laminar nanofluid flow in a curved tube using a two phase approach

Akbarinia, A.; Laur, R.

doi:10.1016/j.ijheatfluidflow.2009.03.002

Cited by 144 publications

(38 citation statements)

References 28 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…They showed the higher accuracy of mixture model with respect to the single phase model and the agreement with experimental correlation proposed by Xuan and Li [10]. Mirmasoumi and Behazadmehr [23] and Akbarinia and Laur [24] numerically studied nanofluids laminar convection. The former analyzed laminar mixed convection in a horizontal tube, while the latter studied the effect of particles diameter on the laminar flow in a curved circular tube.…”

Section: Introductionsupporting

confidence: 69%

Numerical investigation on nanofluids turbulent convection heat transfer inside a circular tube

Bianco¹,

Manca²,

Nardini³

2011

International Journal of Thermal Sciences

215

107

View full text Add to dashboard Cite

Section: Introductionsupporting

confidence: 69%

Numerical investigation on nanofluids turbulent convection heat transfer inside a circular tube

Bianco¹,

Manca²,

Nardini³

2011

International Journal of Thermal Sciences

215

107

View full text Add to dashboard Cite

“…A single-phase numerical study carried out by Akbarinia and Behzadmehr [7] shows that increasing the concentration of the particles increases the heat transfer rate and pressure drop for laminar mixed convection flow of nano-fluid in the horizontal curved pipe. Akbarinia and Laur [8] using a 2-phase approach numerically investigated the effect of the particle diameter on the flow and heat transfer. They stated that increasing the diameter of nano-particles decreases the Nu number, and for nanoscale particles increasing the particle diameter does not change the flow pattern.…”

Section: Introductionmentioning

confidence: 99%

Experimental and numerical investigations of turbulent forced convection flow of nano-fluid in helical coiled tubes at constant surface temperature

et al. 2015

View full text Add to dashboard Cite

“…This may be attributed to reduction of nanoparticles sedimentation rate and cross-sectional mixing enhancement, due to the secondary flow. It should be noted that the nanoparticles volume fraction does not have a direct effect on the secondary flow, also the cross-sectional distribution of solid nanoparticles is uniform because of the small size of the nanoparticles [44][45][46][47]. Figure 8 depicts the variation of relative average total heat transfer coefficient versus Womersly number for different flow rates of the base fluid (deionized water).…”

Section: Heat Transfer In Steady Flow Of Nanofluidmentioning

confidence: 99%

Characteristics of heat transfer and flow of Al2O3/water nanofluid in a spiral-coil tube for turbulent pulsating flow

et al. 2015

View full text Add to dashboard Cite

K Thermal conductivity (W/m K) L Length of tube (m) m Mass flow rate (kg/s) N Revolution per minute of the rotating valve spindle (rpm) Pe Peclet number Pr Prandtl number Q Heat transfer rate (W) r Inner radius of tube (m) R Radius of spiral coil (m) Re Reynolds number T Temperature (K) U Average overall heat transfer coefficient (W/m 2 K) V Average velocity of mean flow (m/s) Wo Womersly number, Wo = D i 2 υ ω Greek letters α Thermal diffusivity (m 2 /s) µ Dynamic viscosity (kg/m s) ρ Density (kg/m 3 ) υ Kinematic viscosity (m 2 /s) ω Angular pulsation frequency (1/s) ∞ Ambient medium ϕ Nanoparticle volumetric fraction Superscript -Average Subscripts ave Average i Inlet m Mean o Outlet pu Pulsated st SteadyAbstract In the past two decades, enhancement of heat transfer characteristics of original fluid using nanofluids has been proposed by a large number of researchers. In this paper, an experimental study was carried out to investigate effect of pulsation on heat transfer of fluid flow inside a spiral-coil tube. In order to perform the experiments, a hot water reservoir tank was prepared and the spiral-coil was immersed horizontally inside the tank. Average temperature of the hot water bath was kept constant at 60 °C to establish a quiescent region of uniform temperature. The experiments were conducted in turbulent flow regime using distilled water and Al 2 O 3 /water nanofluid at 0.5, 1, and 1.5 % particle volume concentration. Results showed that overall heat transfer coefficient of the base fluid flow increases by using nanofluid or pulsation into the base fluid flow up to 14 %. Heat transfer results also indicated that combination of the nanofluid and the pulsation into the fluid flow can increase significantly the overall heat transfer coefficient up to 23 %. List of symbolsA Inside heat transfer area (m 2 ) C p Specific heat capacity (J/kg K) D i Inner diameter of tube (m) f Frequency (Hz)

show abstract

Investigating the diameter of solid particles effects on a laminar nanofluid flow in a curved tube using a two phase approach

Cited by 144 publications

References 28 publications

Numerical investigation on nanofluids turbulent convection heat transfer inside a circular tube

Numerical investigation on nanofluids turbulent convection heat transfer inside a circular tube

Experimental and numerical investigations of turbulent forced convection flow of nano-fluid in helical coiled tubes at constant surface temperature

Characteristics of heat transfer and flow of Al2O3/water nanofluid in a spiral-coil tube for turbulent pulsating flow

Contact Info

Product

Resources

About