The wetting behavior of grain boundaries is affected by temperature, pressure and
misorientation of grain boundaries. However, the influence of quenching baths on liquid state grain
boundary wetting is rarely reported. In this work, this effect in the Sn−25 at% In alloy was
investigated. The Sn−In alloy was prepared by smelting of In and Sn at 300°C for 6 hr in Ar
atmosphere. Samples were annealed at temperature between 130 and 165°C and quenched in two
kinds of baths: −10°C salt-saturated water and liquid nitrogen. The results from X-ray diffraction
show a difference in preferential orientations between samples quenched in these two baths.
Metallographic analysis reveals that the percentage of grain boundaries fully wetted in samples
quenched in −10°C salt-saturated water is lower than that quenched in liquid nitrogen. It is pointed
out that a proper quenching bath is necessary for preserving the initial microstructure of grain
boundary wetting.