Influence of Starkeya novella on Mechanical and Microstructural Properties of Cement Mortars

Advances in Materials Science and Engineering

et al. 2020

Self Cite

Concrete structures placed in aggressive aqueous environments are vulnerable to degradation. Majority of studies have linked structural failures to the ingress of deleterious ions into the cement matrix. Some microbial activities may accelerate the penetration of harmful materials into the cement matrix and hence cause pronounced deterioration. This work reports a laboratory-simulated study carried out to determine the extent of chloride ingress in cement mortars exposed to Acidithiobacillus thiooxidans. Test prisms were cast from Portland pozzolana cement (PPC) and ordinary Portland cement (OPC) with water-to-cement ratio maintained at 0.5. Acidithiobacillus thiooxidans bacterial solution of concentration 1.0 × 10 7 cell/mL was used to prepare microbial mortar prisms, whereas distilled water was used to prepare the control mortar prisms. The test prisms were subjected to porosity and accelerated chloride ingress after 28th day of curing. Compressive strength was determined after the 2nd, 7th, 28th, and 56th days of curing. Apparent diffusion coefficients (Dapp) were estimated from the solutions to Fick’s second law of diffusion. After the 56th day of curing, the microbial-treated mortars exhibited a significant reduction in compressive strength. The resultant percentage decrease in compressive strength was 30.74% and 19.88% for OPC and PPC, respectively. Further, microbial-treated mortars demonstrated both high porosity and chloride ingress as compared to the control test mortars. Scanning electron microscopy (SEM) and X-ray diffraction (XRD) analyses showed the formation of new deleterious products in the microbial-exposed mortars.

“…e formed AFt is expansive and deleterious. Comparable observations have been made by other authors [15,28,[32][33][34].…”

Section: Scanning Electron Microscopy (Sem)supporting

confidence: 85%

Section: Chloride Profilingmentioning

confidence: 99%

Section: Porositymentioning

confidence: 99%

See 1 more Smart Citation

Chloride Ingress in Cement Mortars Exposed to Acidithiobacillus thiooxidans Bacteria

Munyao

Advances in Materials Science and Engineering

et al. 2020

Self Cite

“…The observed micro-cracks/voids were due to excessive internal pressure that resulted from gypsum and ettringite formed as shown in Eqs. (5) and (7) [ 2 ]. This exposed the mortar to possible degradation as these micro-cracks act as pathways (since they are interlinked/interconnected) for aggressive agents’ ingress.…”

Section: Resultsmentioning

confidence: 99%

“…Presence of micro-cracks/voids provides a pathway for ingress of the degrading agents, such cracks can be sealed using biological methods. The metabolic conversion of calcium acetate using Bacilli bacteria has given promising results [ 1 , 2 , 3 ]. This metabolism involves the conversion of organic salt via microbial respiration to deposit calcium carbonate.…”

Section: Introductionmentioning

confidence: 99%

Bioremediation of mortar made from Ordinary Portland Cement degraded by Thiobacillus thioparus using Bacillus flexus

Ngari

et al. 2021

Heliyon

Self Cite

Cement is widely used as a construction material in the construction industry. However, there are challenges affecting its durability efficacy. Cement mortar/concrete is subject to degradation by aggressive ions such as sulphates and chlorides. Sulphates can be introduced into the concrete or mortar by Sulphur producing bacteria of the species Thiobacilli. Microbiologically induced CaCO 3 precipitation (MICP) has found its application in bioremediating cement based materials. It has been found to be environmental friendly. However, no work has been reported on bioremediation of biodegraded cement based materials. This paper presents findings of possible bioremediation of mortars after undergoing biodegradation. Bacillus flexus, a beneficial bacterium was used. The control mortars were prepared using Ordinary Portland Cement (OPC). The test mortars were prepared and cured in a solution of Thiobacillus thioparus, a Sulphur oxidizing bacteria, deleterious bacterium for 14, 28, 56 and 90 days. Compressive strength analysis was conducted on the 14 th , 28 th , 56 th and 90 th day of curing. Results showed that the lowest compressive strength was recorded on the 90 th day as 31.02 MPa. This was a 34.17 % loss in compressive strength. Another category of mortar cured in Thiobacillus thioparus for 28 days was bioremediated for 28 days using Bacillus flexus solution. Compressive strength and Scanning Electron Microscopy (SEM) analyses were then done. The results show a compressive strength of 45.83 MPa at the 56 th day. This represents a 99.91 % strength recovery from biodeterioration. The SEM analysis results revealed a denser material. This was due to massive precipitation of calcium carbonate in the mortar matrix and pores/voids for bioremediated mortars as opposed to the biodegraded mortars. The results further revealed reduced ettringite crystals on the bioremediated mortars. Bacillus flexus could perhaps be used in restoring lost compressive strength as well as in sealing voids in degraded concrete in sewer lines and other cement based materials. This could improve on its efficacy with minimal repair.

Effect of Bacillus cohnii on Some Physicomechanical and Microstructural Properties of Ordinary Portland Cement

Wangui

2020

Journal of Chemistry

Self Cite

Cement-made materials face durability and sustainability challenges. This is majorly caused by the presence of cracks. Cracking affects the mechanical strength of cement-based materials. Microbiologically induced calcite precipitation (MICP) has been found to enhance compressive strength, thus enhancing on the mechanical and durability properties of these materials. This paper presents the findings of a study conducted to investigate the effect of Bacillus cohnii on compressive strength development of OPC mortar prisms and the effect of Bacillus cohnii on cement setting time and soundness. Microbial concentration of 1.0 × 107 cells·ml−1 was used. Compressive strength tests analyses were carried out for each category of mortar prisms. Compressive strength tests were carried out on the 2nd, 7th, 14th, 28th, 56th, and 90th day of curing in distilled water and microbial solutions. All microbial mortars exhibited a greater compressive strength compared to the control with the highest observed at 90 days. Highest percentage gain in compressive strength was observed at 90 days which is 28.3%. Microstructural analysis was carried out using a scanning electron microscope (SEM) after 28 days of curing. The results indicated the presence of calcium carbonate and more calcium silicate hydrate (CSH) deposits on the bacterial mortars. The bacteria did not have an effect on cement soundness. Setting time was significantly accelerated.