Improvement of the technology of ball mills

Sevostyanov, V. S.; Goncharov, A. A.; Potelezhko, V. P.

doi:10.1007/bf00682491

Cited by 7 publications

(3 citation statements)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

Section: Introductionmentioning

confidence: 99%

“…For fine grinding of cement clinker and additives, ball mills of various sizes are mostly used [1,2,6,7]. These grinding units are distinguished by the simplicity of their design, its operation and repair [8][9][10][11][12]. However, a significant amount of energy spent on fine grinding of clinker and additives forces a large number of researchers to offer to the market grinding units based on other grinding principles [13][14][15][16].…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Determination of the ball mills performance, taking into account the particle size of the finished product

Sharapov

2021

E3S Web Conf.

View full text Add to dashboard Cite

The article discusses the issue of determining the newly formed specific surface of the cement clinker taking into account the lateral surface of the seal area. When developing this technique, the assumption that the newly formed particles have a shape close to spherical, has been made. The obtained ratio determines the work that considers the formation of thecement clinker material new surface, depending on the size of the original and newly formed material. An arithmetic expression is given, defined as the minimum amount of energy that must be introduced into the deformation zone for the destruction of a cement clinker particle to occur. The presented technique is specified taking into account the fact that defects are introduced into the crushed material particle. Taking into account the fact that the grinding ball makes an impact in one cycle of its movement, the value of the newly formed surface of the material in the ball mill is determined in one hour of its operation.

show abstract

Section: Introductionmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%

Determination of the ball mills performance, taking into account the particle size of the finished product

Sharapov

2021

E3S Web Conf.

View full text Add to dashboard Cite

show abstract

“…A large number of devices proposed by various researchers for grinding the components of the cement and the Portland cement clinker and additives [6][7][8][9][10][11]. At the same time the requirements for quality of the final product to grinding equipment are very high level.…”

Section: Introductionmentioning

confidence: 99%

Determination of the granulometric composition parameters of the grinding product in a ball mill

Sharapov

2018

MATEC Web Conf.

View full text Add to dashboard Cite

The article deals with the issue of the formation of the grain composition of the comminuted material inside the drum of a ball mill. The approach to the calculation of the grain composition at its transition from a larger fraction from a smaller fraction is presented. The proposed approach was tested on an industrial cement ball mill and confirmed on an experimental installation. This approach allows you to determine the parameters of the kinetics of grinding, depending on the design parameters used ball mills.

show abstract

Determination of the boundary conditions of the grinding load in ball mills

Sharapov

2018

IOP Conf. Ser.: Mater. Sci. Eng.

View full text Add to dashboard Cite

Improvement of the technology of ball mills

Cited by 7 publications

References 0 publications

Determination of the ball mills performance, taking into account the particle size of the finished product

Determination of the ball mills performance, taking into account the particle size of the finished product

Determination of the granulometric composition parameters of the grinding product in a ball mill

Determination of the boundary conditions of the grinding load in ball mills

Contact Info

Product

Resources

About