Improvement of electroluminescent performance of n-ZnO/AlN/p-GaN light-emitting diodes by optimizing the AlN barrier layer

Abstract

The effects of the growth temperature and thickness of AlN layer on the electroluminescence (EL) performance of n-ZnO/AlN/p-GaN devices have been systematically investigated. It is found that the higher growth temperature of AlN layer (T AlN) may facilitate the improvement of EL performance of the device, which is attributed to that the crystalline quality of AlN layer improves with increasing growth temperatures T AlN. Besides the crystallinity of AlN layer, the thickness of AlN barrier layer plays an important role on the performance of the device. The thinner AlN layer is not enough to cover the whole surface of GaN, while the thicker AlN layer is unfavorable to the tunneling of carriers and many of electrons will be captured and recombined nonradiatively via the deep donors within the thick AlN layer. We have demonstrated that the AlN layer at the growth temperature of 700 C with an optimized thickness of around 10 nm could effectively confine the injected carriers and suppress the formation of interfacial layer, thus, the EL performance of n-ZnO/AlN/p-GaN device could be significantly improved. V

Enhanced Electroluminescence from ZnO Quantum Dot Light‐Emitting Diodes via Introducing Al2O3 Retarding Layer and Ag@ZnO Hybrid Nanodots

“…In contrast, for the PAIT Q‐LED, the injected electrons from ITO cathode will first be transported in the T layer and then be retarded (or even blocked) by the inserted Al 2 O 3 dielectric layer (see Figure b). Although most of these injected electrons could still tunnel through this thin Al 2 O 3 layer under forward bias, their migration ability is weakened because these electrons have experienced strong scattering with the Al 2 O 3 host‐lattice/defect‐sites during the tunneling process and lost some of their kinetic energy . In such a case, these electrons will be detained in the A layer QDs emissive region.…”

ALD Oxides-Based <i>n-i-p</i> Heterostructure Light Emitting Diodes

“…The wide band energy of intrinsic layer in LED structure was necessary to obtain a required band offset of more than 1 eV in the conduction band for the n-ZnO semiconductor and less than 1 eV in the valence band for the p-GaN semiconductor. In consequence, the optimized intrinsic layer should block (reduce) the flow of electrons and facilitate the diffusion of holes in the junction structure [21]. This means that the interlayer in junction was desirable because the n-ZnO/p-GaN LED emitted mainly from the p-type GaN region and not from the n-type ZnO.…”

Electroluminescence of ordered ZnO nanorod array/p-GaN light-emitting diodes with graphene current spreading layer

“…Figure 4 b presents the EL spectra of the ZnO nanorod array-based LEDs with different diameters (170, 220, 300, and 380 nm) at the injection current of 6 mA, and all the four diodes show a dominant NBE emission at 390 nm. Compared with the PL spectra, there is a 10-nm red shift of the EL NBE emission, which is caused by the junction-heating effect under a constant injection current [ 14 , 19 ] and difference between PL and EL processes (the PL process depends on the recombination of nonequilibrium carriers in the surface layer, whereas the EL process is determined via the carrier recombination within the space charge region of heterojunction [ 20 ]).…”