Impact of miscentering on patient dose and image noise in x-ray CT imaging: Phantom and clinical studies

Abstract

The operation of the bowtie filter in x-ray CT is correct if the object being scanned is properly centered in the scanner's field-of-view. Otherwise, the dose delivered to the patient and image noise will deviate from optimal setting. We investigate the effect of miscentering on image noise and surface dose on three commercial CT scanners. Six cylindrical phantoms with different size and material were scanned on each scanner. The phantoms were positioned at 0, 2, 4 and 6 cm below the isocenter of the scanner's field-of-view. Regression models of surface dose and noise were produced as a function of miscentering magnitude and phantom's size. 480 patients were assessed using the calculated regression models to estimate the influence of patient miscentering on image noise and patient surface dose in seven imaging centers. For the 64-slice CT scanner, the maximum increase of surface dose using the CTDI-32 phantom was 13.5%, 33.3% and 51.1% for miscenterings of 2, 4 and 6 cm, respectively. The analysis of patients' scout scans showed miscentering of 2.2 cm in average below the isocenter. An average increase of 23% and 7% was observed for patient dose and image noise, respectively. The maximum variation in patient miscentering derived from the comparison of imaging centers using the same scanner was 1.6 cm. Patient miscentering may substantially

Implications of Patient Centring on Organ Dose in Computed Tomography

“…An exception was the eye lens, where the CT-Expo value of 60.6 mGy was higher than the measured mean value of 54.4 mGy. CT Expo values were lower however, for the breast (2.7 mGy vs 4.0 mGy) and thyroid Kaasalainen et al (7) and Habibzadeh et al (5) . These studies showed that when the scanning object was aligned off-center, below the isocenter, there was an increase in dose at the upper surface and an increase in image noise at the lower half of the phantom.…”

Overview, Practical Tips and Potential Pitfalls of Using Automatic Exposure Control in Ct: Siemens Care Dose 4d

“…Optimal functioning of the filters requires appropriate centring of the patients. Miscentring can increase the surface radiation dose and image noise and introduce artefacts (17) . When two orthogonal localizers were acquired, a vertical miscentring of 5 cm had less effect on the tube current modulation (CTDI vol increased 1%) than using a single localizer.…”

Quality control of CT systems by automated monitoring of key performance indicators: a two‐year study

“…From a clinical view point this is important as it has been shown that patient miscentering may lead to both higher surface doses and noisier images (10) . Positioning depends on the precision of the gantry lasers and the functionality of the tabletop of the CT scanner.…”