Hysteresis Current Control of a Permanent Magnet Brushless DC Motor PV Pumping System

Moussi, A.; Terki, Amel; Asher, G.M.

doi:10.1115/isec2005-76253

Cited by 6 publications

(4 citation statements)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…ey conclude that after comparison, the DC motor has the advantage of higher utilization of PV power, and direct coupling between the DC motor and the PV generator reduces the cost of the system [4][5][6][7].…”

Section: Literature Workmentioning

confidence: 94%

Design and Implementation of Automatic Water Spraying System for Solar Photovoltaic Module

Kumar¹,

Indragandhi

Teekaraman

et al. 2022

Mathematical Problems in Engineering

View full text Add to dashboard Cite

Photovoltaic (PV) cell has a characteristic of decrease in power beyond a certain temperature. This decrease in power is due to a drop in the open circuit cell voltage. This decreases the efficiency of the PV cell. The objective of this research is to increase the efficiency of PV cells by reducing the PV cell temperature and reflection loss. The cell temperature and reflection loss can be reduced by spraying water over the PV cells. On spraying water over the USP36, 24V PV module, the power is found to be increased. The test result shows a 1V to 2V increase in voltage, with an efficiency increment of 1% to 1.27%. The test results of USP37 show the voltage increase of 1.2 V to 2.1 V in the PV module voltage. Due to the increase in voltage, efficiency increment of 1.29% is observed. The efficiency of USP36 with water spraying is more than the efficiency of USP37 without water spraying. In the PV power systems, an average increase in efficiency of 0.5% is observed.

show abstract

Section: Literature Workmentioning

confidence: 94%

Design and Implementation of Automatic Water Spraying System for Solar Photovoltaic Module

Kumar¹,

Indragandhi

Teekaraman

et al. 2022

Mathematical Problems in Engineering

View full text Add to dashboard Cite

show abstract

“…The large number of publications have been reported on the solar energy-based water pumping systems utilising a DC motor, an induction motor (IM), a PM brushless DC motor (BLDC) and a PM synchronous motor (PMSM) drives [7][8][9][10][11][12]. The PV generator-based water pumping system employing IM [8] suffers from the problems of complex control, low efficiency and poor starting performance.…”

Section: Introductionmentioning

confidence: 99%

“…However, the constraints of PMSM such as high cost and the performance degradation under abnormal environmental conditions make SRM drive better option for solar PV fed water pumps. The system employing a BLDC motor for the water pumping system is reported in [10,11]. It has the advantage of few sensors requirement, small losses and robust in nature.…”

Section: Introductionmentioning

confidence: 99%

Control of SRM drive for photovoltaic powered water pumping system

Mishra

Singh

2017

IET Electric Power Applications

View full text Add to dashboard Cite

The aim of present study is to develop a 'Luo' converter-based low-cost solar powered water pumping scheme utilising a switched reluctance motor (SRM). The speed of SRM drive is controlled by adjusting the DC-bus voltage of splitcapacitor converter. The converter is electronically commutated at fundamental frequency for low switching losses. A 'Luo' DC-DC converter working in continuous inductor current and capacitor voltage modes (continuous inductor current mode and continuous capacitor voltage mode) is utilised to feed power to SRM drive through a split-capacitor converter. It also provides the limitless sector of maximum power point tracking (MPPT). The elimination of current and voltage sensors on the motor side owing to variable speed operation of the motor drive makes the system costeffective and reliable. The soft-starting of SRM drive is also achieved through the proper step size and initial duty cycle selection through MPPT algorithm. The performance of SRM system is validated by both Simulink/MATLAB platformbased model and responses of developed prototype.

show abstract

“…These machines have the advantages of light weight, small size, simple mechanical construction, easy maintenance, good reliability, and high efficiency [1,3,4,5]. In general, the motors are equipped with mechanical position detecting devices to provide proper commutation for power devices in the bridge inverter [6].…”

Section: Introductionmentioning

confidence: 99%

Design of ANFIS Estimator of Permanent Magnet Brushless DC Motor Position for PV Pumping System

Terki¹,

Moussi²,

Terki³

2015

ijacsa

View full text Add to dashboard Cite

Abstract-This paper presents a new scheme for PMBLDC (permanent magnet brushless direct current) rotor position estimation based an ANFIS (adaptive network fuzzy inference system) estimator. The operation of such motor requires accurate rotor position knowledge. However, most of rotor position sensors produce undesirable effects such as mechanical losses and have other disadvantages. In order to overcome the disadvantages, sensorless scheme seems to offer great advantages. This work present an ANFIS estimator design. Combining the adaptive capability of the neural network to gather with the reasoning ability of the fuzzy logic in ANFIS modeling results in a fast responding and flexible model. This procedure lends itself perfectly adapted for complex system such as PV pumping systems.

show abstract

Hysteresis Current Control of a Permanent Magnet Brushless DC Motor PV Pumping System

Cited by 6 publications

References 0 publications

Design and Implementation of Automatic Water Spraying System for Solar Photovoltaic Module

Design and Implementation of Automatic Water Spraying System for Solar Photovoltaic Module

Control of SRM drive for photovoltaic powered water pumping system

Design of ANFIS Estimator of Permanent Magnet Brushless DC Motor Position for PV Pumping System

Contact Info

Product

Resources

About