Hypothetical study on waste heat recovery and filtration system of cement manufacturing process in cement industry

Rajendran, Manikandan; Sriramhariharasudhan, K.; Shanmugavel, Rajesh; Rajpradeesh, T.; Sankaranarayanan, Bathrinath

doi:10.1016/j.matpr.2021.02.286

Cited by 1 publication

(1 citation statement)

References 35 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…CEMS is a sensor that continuously monitors air quality emission, while ESP and jet pulse filters are served to reduce the severity of dust coming out of the system. 23 In addition, bag filters can reduce dust emissions, and more effective in removing dust than Electrostatic Precipitator (ESP). 24 Heat control is used to keep the tool away from the damage, namely lowering the amount of fuel and inching kiln.…”

Section: Discussionmentioning

confidence: 99%

Bowtie Method: Study of Occupational Health and Safety Risks in Cement Production Process

Putri

Lestari

Novrikasari

et al. 2021

MKMI

View full text Add to dashboard Cite

The kiln area is an area that has a very complex hazard potential in the cement production process. This study aimed to assess the risks of occupational safety and health during the production process in the kiln area of PT. X uses the bowtie method. This study used a qualitative descriptive design. The informants used were three managers of the clinker production department, one safety manager, and one field operator. Research data were collected through interviews and observations. The data were analyzed qualitatively using the bowtie method. The study results stated that hot dust could be dangerous if it comes out of the system caused by positive pressure, such as the Induced Draft Fan (IDF) turning off, causing losses such as burns to workers. Heat can be dangerous if it experiences a significant increase due to excess fuel, causing losses, such as health-related illnesses. Preventive controls were carried out such as routine inspections. Mitigation controls were carried out such as light signals. Escalation factors can thwart hot dust and heat control, such as the deformation of raw meals. Escalation factor control, such as the implementation of work instructions. PT. X has carried out control in the kiln area, but additional controls are needed.

show abstract

Section: Discussionmentioning

confidence: 99%