Hydrogenation and annealing impact on Si/CdTe junction for solar energy application

Kumar, Hemant; Singh, M.

doi:10.1016/j.ijhydene.2022.06.031

Cited by 2 publications

(1 citation statement)

References 20 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The CdS/CdTe solar cell has been recognized as one of the potential possibilities for developing sound photovoltaic systems [5]. CdTe has recently gained attention due to its many applications, such as photovoltaics [6], x-ray sensors [7], solar energy water splitting [8], imaging detectors [9], optoelectronics [10], and radiation detectors [11].…”

Section: Introductionmentioning

confidence: 99%

Influence of growth time on the properties of CdTe thin films grown by electrodeposition using acetate precursor for solar energy application

Yimamu

Afrassa

Dejene

et al. 2023

Mater. Res. Express

View full text Add to dashboard Cite

Cadmium telluride (CdTe) thin films were deposited using a two-electrode electrodeposition configuration from an aqueous acidic solution. The electrolyte solution contains 1 M of cadmium acetate dihydrate (Cd (CH3OO) 2.2H2O) as cadmium precursor and 1 ml of tellurium dioxide (TeO2) as tellurium precursor. The thin films were grown for different deposition times of 60, 120, 180, 240, and 300 min to investigate the effect of the deposition period on the structural, optical, electrical, surface morphology, elemental composition, and surface roughness properties of the CdTe thin films in both as-deposited and heat-treated forms. X-ray diﬀraction (XRD) analysis indicates that the CdTe thin films have polycrystalline cubic zinc blend, orthorhombic and hexagonal structures. The result confirmed that the cubic phase is dominant and (111) plane is the preferential orientation peak. Ultraviolet-visible (UV-Vis) spectrophotometry study shows that the band gap of the as-deposited thin films varies from (1.41-1.45) eV, and after heat treatment, the band gap decreased to (1.35-1.42) eV. Photoelectrochemical cell (PEC) measurements show that CdTe thin films have n-type conductivity in both as-deposited and annealed forms. Scanning electron microscopy (SEM) analysis shows that the surface morphology of CdTe thin films changed as the deposition period increases. After heat treatment, the improvement in grain size was observed. Energy-dispersive X-ray spectroscopy (EDS) analysis shows that the percentage composition of as-deposited CdTe thin films varied with deposition time, with the best composition being recorded at 120 min deposition time. After post-deposition heat treatment (HT), the elemental compositions of Te decreased, and that of Cd increased. When the thin film was deposited at 120 min, the film with stoichiometric composition was observed after heat treatment. Scanning probe microscopy (SPM) measurements revealed that the average surface roughness of the thin films varied with deposition time, with the sample grown for 120 min showing the highest roughness.

show abstract