Granular Polymeric Carbon Nitride with Carbon Vacancies for Enhanced Photocatalytic Hydrogen Evolution

Abstract

Considering the high charge recombination rate, low optical adsorption intensity and limited active sites greatly constrict the solar‐to‐chemical conversion efficiency of polymer carbon nitride. Herein, a facile approach is reported to produce defected polymeric carbon nitride (PCN) with abundant granular bulks with fractured boundaries by thermal reduction treatment in CO atmosphere. The photocatalytic hydrogen evolution over defected PCN exhibits a rate of 3281.2 μmol g−1 h−1, 3.5 times higher than the pristine, which is most possibly ascribed to the following factors. The unique defected and porous structure not only provides higher specific surface area, more exposed active edges, abundant charge separation sites, and active centers for hydrogen generation but also is beneficial to rapid mass and charge transfer, interior diffusing of incident light, and shortening carrier transport length, thus enhancing the optical adsorption and accelerating the photocatalytic reaction kinetics. Furthermore, the electron delocalization at carbon vacancies sites on one hand facilitates the separation rate of electron–hole pairs and prolonged the carrier lifetime; on the other hand, the electronic polarization caused by C atoms loss helps increasing the affinity between catalyst and substrate reactant. Moreover, the higher electron donor density and lower conduction band minimum (CBM) potential further enhance the reduction capacity for H2 evolution.

Efficient sunlight promoted nitrogen fixation from air under room temperature and ambient pressure via Ti/Mo composites

“…Figure 5b shows the electron paramagnetic resonance (ESR) test diagram of sample TMC3 and TiO2. Sample TMC3 has an obvious peak at g = 2.001 [46][47][48], and pure TiO2 has no obvious signal peak. This may be due to the carbon vacancy defects caused by the deletion of carbon atoms during the formation of Mo2C by argon high-temperature sintering.…”

State-of-the-art advances in vacancy defect engineering of graphitic carbon nitride for solar water splitting

“…Considering the easily-realized higher hydrogen evolution rate compared to that of OWS, photocatalytic partial water splitting (PPWS) has been the most widely researched approach for solar hydrogen production, despite the cost of the sacrificial agent [75] . A sacrificial reagent captures the photo-generated holes, fostering the evolution rate of hydrogen.…”

Photocatalytic Degradation of Xylene by Carbon Quantum Dots/Clinoptilolite Composites

“…characteristic peaks at binding energies of 284.8 eV, 286.8 eV, and 288.6 eV in Catalyst No. 1 were attributed to C 1s, C=O, and carboxyl groups, respectively[35]. The characteristic peaks appearing at binding energies of 284.8 eV and 286.8 eV for the original zeolite were attributed to C 1s and C=O, respectively, while the intensity was much lower compared to Catalyst No.…”