GA-based multi-objective optimization for distributed generations planning with DLMs in distribution power systems

Abstract

Please cite this article in press as: Singh, B., et al., GA-based multi-objective optimization for distributed generations planning with DLMs in distribution power systems. J. Electr. Syst. Inform. Technol. (2016), http://dx. AbstractIn the present scenario of all over world, the planning of distributed generations (DGs) in distribution power systems are very important issues from power system performances viewpoints. The broad categories of different types of DGs on the basis of their power delivering characteristics are considered T 1 , T 2 , T 3 and T 4 with different load models (DLMs) for the analysis in this paper. This paper presents the impact assessment of optimally placed different types of DGs (such as T 1 , T 2 , T 3 and T 4 ) with DLMs by employing genetic algorithm (GA) in the distribution power systems (DPSs) form total minimum real power loss of the system viewpoint. Different DPS performance parameters such as minimization of real power loss, minimization of reactive power loss, improvement of voltage profile, reduction of the short circuit current or MVA line capacity and reduction of the environmental green house gases like carbon dioxide (CO 2 ), sulphur dioxide (SO 2 ), nitrogen oxide (NO x ) and particulate matters in emergency e.g. under fault, sudden change in field excitation of alternators or load increase in the distribution power system are considered. The contribution of the present work is to investigate the comparisons of different DGs with DLMs by excercizing GA in the distribution systems form minimum total real power loss of the system viewpoint. The effectiveness of the proposed methodology is tested on IEEE-37 bus distribution test system. The different types of DGs (such as T 1 , T 2 , T 3 and T 4 ) with DLMs have shown different behaviours for power system performance indices such as PLI, QLI, VDI, SCCI and EIRI viewpoints. The sequence of overall power system performance indices such as PLI, QLI, VDI, SCCI and EIRI are as follows: T 2 > T 1 > T 4 > T 3 . This paper presents that the overall performance of T 2 type DG is better as compared to T 1 , T 3 and T 4 types DGs in the distribution system form minimum real power loss of the system viewpoint.Please cite this article in press as: Singh, B., et al., GA-based multi-objective optimization for distributed generations planning with DLMs in distribution power systems. J. Electr. Syst. Inform. Technol. (2016), http://dx.

Optimal allocation of distributed generation and electric vehicle charging stations based on intelligent algorithm and bi‐level programming

“…In this article, the IHPSO algorithm and the PSO algorithm are tested by the test functions f 1 (x)~f 4 (x). (2).33 (5).38 (10).21 (4).50 (10).66 (10) (2).38 (10).21 (2).50 (9).66 (9) (12).10(15).11 (15).12 (10).13 (11).14 (15).23 (8).24 (12).25 (11).26 (11).27 (14).28 (15).29 ( (15).9 (15). 10(15).11 (12).12 (7).13 (13).14 (15).23 (8).24 (12).25 (1).27 (7).28 (12 (14).9 (14).…”

“…The work by Kayalvizhi and Vinod 4 builds a multiobjective optimisation model that simultaneously consider power loss minimisation, voltage shift minimisation and cost minimisation, and the validity of the programming model is verified by three examples. The work by Singh et al 5 builds an optimal allocation model for DG with constraints for reactive power optimisation and network reconfiguration. The intelligent heuristic algorithm is used to obtain optimal solution.…”

Optimal Allocation of Hybrid Renewable Energy System by Multi-Objective Water Cycle Algorithm

“…summer day load model (SDM) and winter day load model (WDM) loads are adopted in. The real and complex power of the load is considered as constant power in the classical load flow problems, despite, the load may be nonlinear such as industrial load residential and commercial which discussed by models in [25]. The nonlinear dependent voltage load model is represented by exponential function as the following form:…”

“…In the classical power flow solution, the load is suggested to be fixed power, where α = β = 0. For nonlinear loads representing commercial and residential, the real and complex power components are given in Table 2 [25]. The produced energy of FC is described as follows [26]:…”

Integrated monte carlo-evolutionary programming technique for distributed generation studies in distribution system

“…They are frequently utilized as a part of physical and numerical issues and are most valuable when it is troublesome or difficult to utilize different methodologies. Monte Carlo strategies are essentially utilized as a part of three particular issue classes: optimization, numerical integration and getting a draws from probability distribution [25].…”