Fabrication, Structure, and Thermal Properties of Mg–Cu Alloys as High Temperature PCM for Thermal Energy Storage

Abstract

This work studied the thermophysical properties of Mg-24%Cu, Mg-31%Cu, and Mg-45%Cu (wt.%) alloys to comprehensively consider the possibility of using them as thermal energy storage (TES) phase change materials (PCMs) used at high temperatures. The microstructure, phase composition, phase change temperatures, and enthalpy of these alloys were investigated by an electron probe micro analyzer (EPMA), X-ray diffraction (XRD), and differential scanning calorimetry (DSC). The XRD and EPMA results indicated that the binary eutectic phase composed of α-Mg and Mg2Cu exists in the microstructure of the prepared Mg–Cu series alloys. The microstructure of Mg-24%Cu and Mg-31%Cu is composed of α-Mg matrix and binary eutectic phases, and Mg-45%Cu is composed of primary Mg2Cu and binary eutectic phases. The number of eutectic phases is largest in Mg-31%Cu alloy. The DSC curves indicated that the onset melting temperature of Mg-24%Cu, Mg-31%Cu, and Mg-45%Cu alloys were 485, 486, and 485 °C, and the melting enthalpies were 152, 215, and 91 J/g. Thermal expansion and thermal conductivity were also determined, revealing that the Mg–Cu alloys had a low linear thermal expansion coefficient and high thermal conductivity with respect to increasing temperatures. In conclusion, the thermal properties demonstrated that the Mg–Cu alloys can be considered as a potential PCM for TES.

Research Progress of Photovoltaic Cooling Systems Based on Phase Change Materials: An Overview

“…The density of the composite was increased by almost 75% to 1.05 g cm −3 , indicating that different composite filler materials and synthesis methods have different effects on the bulk energy storage density and thermal power capacity. Sun et al [ 88 ] investigated the thermophysical properties of Mg‐24%Cu, Mg‐31%Cu, and Mg‐45%Cu alloys, including their microstructure, phase composition, phase transition temperature, and enthalpy. The test results show that the Mg‐24%Cu, Mg‐31%Cu, and Mg‐45%Cu alloys have starting melting temperatures of 485, 486, and 485 °C and melting enthalpies of 152, 21, 5, and 91 J g −1 .…”

Thermal properties and container compatibility of (Al0.8Si0.2)100−xBix phase change energy storage alloys

“…Researchers have shown significant interest in developing energy storage alloys suitable for high-temperature environments in recent years. The Mg-Cu systems [3] and Mg-Al systems are commonly studied [4]. Mg-Cu--based alloys often have relatively small phase change enthalpy, resulting in higher energy consumption in practical applications.…”

Copper–Alumina Capsules for High-Temperature Thermal Energy Storage

“…In comparison to microcapsules (with a PCM sphere diameter of <1 mm), the macrocapsules (with a PCM sphere diameter of >1 mm) present a higher ratio of core to shell, resulting in a higher thermal energy density of the TES systems . However, due to the large volume expansion of Cu-based PCMs at high temperatures, the shells of the capsules may crack during the phase-change transition, resulting in the leakage of the liquid metals. − To overcome this issue, the sacrificial layer method can smartly create a buffer cavity inside the macrocapsules. Mathur et al coated the sacrificial layer and shell on the core for inorganic salt mixture PCMs by the fluid bed method.…”