Experimental investigation of the influence of wool structures on the stab resistance of woven body armor panels

Abstract

In the production of body armor panels, multilayer aramid fabrics are normally used. A main problem of these panels is the high weight and consequential lower comfort for the wearer. In a recent survey it was shown that most officers in the United States would prefer an improved comfort and also reduced weight in their ballistic vests. To reduce layers with a concomitance of the same safety standards, the panel has to be improved. One solution is to reduce the slippage of the yarns during the penetration of the knife and with this to increase the absorbed impact energy. The tests showed that the placement of a layer of wool fabric on the top of the aramid panel changes the penetration behavior. The main goal of this work is the investigation of the influence of the woven wool structure over the penetration of aramid panels. For this investigation, the stab resistance of five aramid fabrics with different properties and patterns combined with one layer of wool on the top and bottom of the panel has been tested and compared against pure aramid panels, according to the VPAM test instruction “Stab- and Impact Protection”. In addition, an optical evaluation of the stab tests has been done using a high-speed camera. Also, the stab recess in the aramid layers was evaluated optically, using a digital microscope. The experimental results confirm that wool can increase the stab resistance of body armor panels, but results are dependent on the properties and pattern of the aramid fabrics, too.

Body armor for stab and spike protection, Part 1: Scientific literature review

“…A recent review discussed the use of nano additives for stab and spike protection. 150 Future armor will use the nano additives such as carbon nanospheres, carbon nanotubes, and the structures of nanofibers to improve stab and spike protection.…”

Polyethylene terephthalate/basalt stab-resistant sandwich composites based on the Box–Behnken design: Parameter optimization and empirical regression model

“…The failure mechanism of knife stab probe depends on the force of friction and shear force between the knife and the LPET fibers and basalt yarns, which in turn leads to the breakage of LPET fibers and basalt yarns [22,23]. Unlike the spike stab, the knife stab causes the breakage of the fibers as well as bundles of fibers of the sandwich composites [13,24]. The fractured patterns are shown in Figure 7(a) and (b).…”

“…Reiners et al. placing one-layer woven wool structure on the top and bottom of the panels increased the stab resistance of resulting body armor [13]. Suhaimi et al.…”

Thermally Bonded PET–Basalt Sandwich Composites for Heat Pipeline Protection: Preparation, Stab Resisting, and Thermal-Insulating Properties

“…Comparatively, knife-resistance force and energy of thermal treatment for 5 min are larger than other thermal durations, which represents the best knife-resistance performance. Under the action of knife, surficial nonwoven and interlayer BF are both damaged, and the failure surface presents a thin and long cut, which results from the cutting, friction between yarns, and friction between knife and yarns, as well as tensile plastic deformation [20]. The higher friction coefficient between yarns can generate a larger knife-resistance load and energy [21].…”