Experience in Developing a Physical Model of Submersible Electrical Equipment for Simulator Systems: Research and Training Tasks on the Agenda of a Key Employer

Петроченков, А. Б.; Ромодин, А. В.; Mishurinskikh, Sergey; Seleznev, Vladimir V.; Shamaev, Vitaliy A.

doi:10.1109/ptes.2018.8604169

Cited by 7 publications

(6 citation statements)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The ESP and SEM operating modes parameters determination is an important task, both from the viewpoint of the equipment correct selection at the well design stage, and from the viewpoint of energy efficiency at the its operation stage [52].…”

Section: Discussionmentioning

confidence: 99%

Software Complex for Sensorless Control of an Electrical Submersible Pump

Iudin,

Petrochenkov,

Solodkiy

et al. 2024

IEEE Sensors J.

View full text Add to dashboard Cite

The article describes design principles of sensorless observing and control system of electrical submersible pump's induction motor based on dynamic state estimation using unscented Kalman filter. The artificial lift method with electrical submersible pumps in the oil industry is associated with measurements of technological parameters from which oil fluid flow rate is one of the most important. To develop sensorless control and parameters observing system the design principles of flow rate observers were proposed. The main possible scenarios for flow rate observation are considered, including those using surface-mounted sensors. The article also considers issues relating to the limitations in flow rate observation by usage pump catalog characteristics, involving control electric drive test signals changing the pump rotational speed. Overcoming these problems is proposed to the electrical submersible pump's flow rate observing system based on a machine learning model. The simulation results using a complex electrical submersible pump model confirming the efficiency of the proposed methods are provided.

show abstract

Section: Discussionmentioning

confidence: 99%

Software Complex for Sensorless Control of an Electrical Submersible Pump

Iudin,

Petrochenkov,

Solodkiy

et al. 2024

IEEE Sensors J.

View full text Add to dashboard Cite

show abstract

“…However, the equipment often installed in laboratories has significantly lower power and lower rated voltage than equipment installed on real objects. When using the approach based on the similarity theory, in the initial data processing similarity coefficients are determined, and through them a transition is made from the results obtained at laboratory benches to the parameters of the operating modes of real objects [33]. The disadvantage of this approach in modeling the load system is that it does not take into account the change in the energy characteristics of the gas turbine engines in the non-nominal operating modes.…”

Section: Discussionmentioning

confidence: 99%

Principles of Imitation for the Loading of the Test Bench for Gas Turbines of Gas Pumping Units, Adequate to Real Conditions

et al. 2021

View full text Add to dashboard Cite

The purpose of the study is to analyze the prospects for the development of loading methods for gas turbines as well as to develop a mathematical model that adequately describes the real operating conditions of the loading system at various loads and rotation speeds. A comparative analysis of the most common methods and technical means of loading the shafts of a free turbine at gas turbine plants intended for operation as part of gas pumping units is presented. Based on the results of the analysis, the expediency of using the loading model “Free Power Turbine Rotor–Hydraulic Brake” as a load simulation is shown. Recommendations for the creation of an automation system for the load testing of power plants have been developed. Mathematical models and Hardware-in-the-Loop simulation models of power plants have been developed and tested. One of the most important factors that predetermine the effectiveness of the loading principle is the possibility of software implementation of the loading means using software control systems that provide the specified loading parameters of the gas turbine.

show abstract

“…The coefficients of the efficiency polynomials of some ESPs used at oil production enterprises are presented in Table 1 [21]. The parameters of the SEM equivalent circuit are determined by the formulas [20,22]:…”

Section: Calculation Of Esp Power Consumptionmentioning

confidence: 99%

“…The motor power factor at different load and voltage at the terminals, different from the nameplate, is calculated by the formula [22,23]:…”

Section: Calculation Of Esp Power Consumptionmentioning

confidence: 99%

See 1 more Smart Citation

Assessment of the Harmonics Influence on the Power Consumption of an Electric Submersible Pump Installation

et al. 2022

View full text Add to dashboard Cite

Oil production is a complex technological process that requires significant electricity consumption. The main electricity consumers in oil and gas production workshops are artificial lift facilities. Currently, among the objects of mechanized mining, installations of electric submersible pumps are widespread. When planning technological modes, it is necessary to be able to assess the change in the power consumption parameters when changing the technological process parameters. The paper proposes a typical replacement scheme for the electrical complex element. The power consumption calculation of electric submersible pump installations has been carried out. The error in the power consumption modeling results of electric submersible pump installations in comparison with the results of instrumental measurements is no more than 10%. The estimation of additional losses of electric energy caused by the influence of harmonics is carried out. The proposed technique makes it possible to estimate the power consumption of an electric submersible pump installation when changing the parameters of the technological process and equipment. The results of the work can be used for planning material support and optimization of warehouse stocks within the framework of integrated logistics support for the technological process of industrial enterprises.

show abstract

Experience in Developing a Physical Model of Submersible Electrical Equipment for Simulator Systems: Research and Training Tasks on the Agenda of a Key Employer

Cited by 7 publications

References 3 publications

Software Complex for Sensorless Control of an Electrical Submersible Pump

Software Complex for Sensorless Control of an Electrical Submersible Pump

Principles of Imitation for the Loading of the Test Bench for Gas Turbines of Gas Pumping Units, Adequate to Real Conditions

Assessment of the Harmonics Influence on the Power Consumption of an Electric Submersible Pump Installation

Contact Info

Product

Resources

About