Elimination of Thermal Bridges in the Construction of a Flat Low-Pressure Solar Collector by Means of a Vacuum Thermal Insulation Bushing

Abstract

The paper deals with the elimination of heat losses in a flat low-pressure solar collector caused by direct contact of outlet pipefitting and the Al–Mg collector box. This is manifested by reduced thermal efficiency of the solar collector, especially in cold season, which is in direct conflict with its application, i.e., high-temperature application and application in cold conditions. The solution lies in the proposed new structural element—the vacuum thermal insulation bushing, which is able to simultaneously provide vacuum tightness of the collector box and interrupt the existing thermal conductive connection. The design philosophy was to transfer the vacuum insulating function component from the original pipe—collector box connection to the thermally insulated place bushing—collector box. Two prototypes were constructed and built into experimental vacuum chamber. Significant increase in the temperature gradient was found in performed experiments. Thermal insulation function, vacuum tightness, and resistance to thermomechanical stress have been demonstrated. The thermal insulation function has also been described through the simulations on a computational model, using finite volume method. The proposed solution of bushing has also successfully become the subject of patent protection.

Investigation of Strain‐Rate Effects in Ni/PU Hybrid Foams under Low‐Impact Velocities

“…Open-cell metal foams are used as heat exchangers, filters, silencers, and vibration dampers. [21][22][23][24] The foam must be able to withstand partially static as well as dynamic loads in the different applications.…”

Numerical Analysis of Concentrated Solar Heaters for Segmented Heat Accumulators

“…The concept of the concentrated solar heater of segmental heat accumulators was evaluated from the point of view of achieving selected values of operating parameters: average and daily temperature course of the heat accumulator temperature and the average temperature of the solar glass vacuum tube. The proposed design was assessed through numerical CFD analysis, which saves time, costs, working material, and with which the authors have many years of experience [44]. The analyzed geometry was simplified by eliminating the support system and chassis, which do not occur in the process of heat accumulation.…”

Mathematical-Physics Analyses of the Nozzle Shaping at the Aperture Gas Outlet into Free Space under ESEM Pressure Conditions

“…These chambers are separated by a small aperture so that it is possible to maintain the pressure gradient during pumping, where the operating pressure in the specimen chamber is in the order of about 2000 Pa (it can be less or more), and the differential pumped chamber, where the pressure is at least an order of magnitude lower [ 19 , 20 ]. There are high demands on this aperture [ 21 ].…”