2019
DOI: 10.1016/j.apsusc.2019.06.015
|View full text |Cite
|
Sign up to set email alerts
|

Electrochemical behavior of boron-doped mesoporous graphene depending on its boron configuration

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
4
1

Citation Types

0
24
0

Year Published

2019
2019
2023
2023

Publication Types

Select...
5

Relationship

1
4

Authors

Journals

citations
Cited by 63 publications
(26 citation statements)
references
References 40 publications
0
24
0
Order By: Relevance
“…BC 3 and BC 2 O enhance electrical conductivity of the electrode and redox properties, while interfacial redox reactions on carbon surface are induced by BC 2 O and B 2 O 3 . [109,110] The reactive B-O groups make the surface hydrophilic and lead to the higher electrochemically active surface area, although the measured BET surface area is found to be lower in B-doped carbon structures than in its pristine counterpart. [111] Although B-doped mesoporous rGO (B-rGO) exhibits higher gravimetric capacitance of 336.4 F g −1 at 0.1 A g −1 in 6 m KOH versus a saturated calomel electrode (SCE), the rate performance is poor with respect to the rGO and calcined B-rGO under the same test conditions ( Table 1).…”
Section: Role Of B-configurations and B-contentmentioning
confidence: 99%
“…BC 3 and BC 2 O enhance electrical conductivity of the electrode and redox properties, while interfacial redox reactions on carbon surface are induced by BC 2 O and B 2 O 3 . [109,110] The reactive B-O groups make the surface hydrophilic and lead to the higher electrochemically active surface area, although the measured BET surface area is found to be lower in B-doped carbon structures than in its pristine counterpart. [111] Although B-doped mesoporous rGO (B-rGO) exhibits higher gravimetric capacitance of 336.4 F g −1 at 0.1 A g −1 in 6 m KOH versus a saturated calomel electrode (SCE), the rate performance is poor with respect to the rGO and calcined B-rGO under the same test conditions ( Table 1).…”
Section: Role Of B-configurations and B-contentmentioning
confidence: 99%
“…The Raman spectrum of MG is shown in Figure (b), including the two characteristic peaks of graphene D and G bands that correspond to ~1340 cm −1 and 1586 cm −1 , respectively. The D band is associated with defects and the peak intensity was increased while the G band originated from the in‐plane vibration of sp 2 carbon‐bonded pairs . The relative intensity ratio I D / I G was 1.03, and it was related to structural defects such as boundaries, heteroatom doping, disorders, and vacancies .…”
Section: Resultsmentioning
confidence: 97%
“…Figure (a) shows the XRD patterns of MG, with a loss of GO peak ( 100 ) at approximately 12.8° due to the removal of oxygen‐containing functional groups and appearance of a broad ( 002 ) peak. This demonstrates the recovery of the graphitic structure and development of a few‐layered graphene . The Raman spectrum of MG is shown in Figure (b), including the two characteristic peaks of graphene D and G bands that correspond to ~1340 cm −1 and 1586 cm −1 , respectively.…”
Section: Resultsmentioning
confidence: 98%
See 2 more Smart Citations