Electric current as a source of information about control parameters of indirect injection fuel injector

Abstract

The article discusses results of the laboratory experiments in which fuel injectors used in indirect injection internal combustion engines were tested. During the experiments, numerous dosing cycles of the injectors were performed while changing the control parameters, due to which, the dosing characteristics were developed and influence of applied parameters on the resultant fuel flow determined. Simultaneously, the voltage and electric current waveforms in the injector coil were recorded, due to which finding links between the electric current characteristics and the determinants of the injector work was possible. The investigation has shown that parameters of electric current constitute a precise criterion for assessing the operation of the solenoid valve, because fuel flow is created due to the work ofelectric current. Thus, by observing the changes in the current flowing through the valve coil,it is possible to monitor precisely the correctness of the process of opening the flow and the electric current intensity, at which the flow began and to determine the mechanical quantities such as fuel dose and pressure. As a result, a characteristic is developed, that provides the links between the fuel pressure and the electric current at the point of lifting the needle, which is quite a novel approach. Such a characteristic can be used in diagnostics and control of fuel injectors as well as all kinds of electromagnetic valves

Application of Magnetic Sensor for Magnetic Profile (1D) and Surface (2D) Measurement of Automotive Wheels

“…The current measured by a handheld device in acceleration phase is i a = 1.24 A, during measurement, i m = 0.37 A, and during deceleration, i d = −0.19 A. This is adequate to magnetic flux densities measured 0.6 m from the power cable B a = 0.07 × 10 −7 T, B m = 0.02 × 10 −7 T, B d = −0.009 × 10 −7 T calculated using Biot-Savart law [ 17 , 25 ]. Please note that B m is significantly lower than the HMC5883L magnetic sensor’s resolution and accuracy, which is 0.48 × 10 −7 T and 2 × 10 −7 T accordingly.…”

Electric Current Waveform of the Injector as a Source of Diagnostic Information

“…The purpose of the pressure coefficient ( ) [ 32 ] is to obtain the modeled electric current value in the range according to the actual value. Depending on the modeled waveform segment, this coefficient takes different values.…”

Comparison between Hybrid and Fuel Injection Motorbikes

“…By decreasing fuel consumption, it decreases carbon emission and other greenhouse gases emission. The current also gives us the characteristics of its fuel injection system [18]. Fig.…”