Effect of Temperature on Corrosion Behavior and Mechanism of S135 and G105 Steels in CO2/H2S Coexisting System

Abstract

The corrosive environment of oilfield condensate water was simulated at different temperatures with CO2/H2S. Weight-loss corrosion tests were conducted on S135 and G105 steels at different temperatures. The corrosion rates of the S135 and G105 were measured at room temperature, 100 °C and 180 °C. The phase structure of the corrosion products and the corrosion morphologies of the samples were characterized. The results show that the corrosion rates of the S135 and G105 increased at first and then decreased with the increase in temperature. The corrosion rates peaked at 100 °C, reaching 0.8463 mm/y and 0.8500 mm/y, respectively. CO2 was the main controlling factor in the corrosion. The corrosion products were FeS and FeCO3. The corrosion rate at room temperature was lower than that at 100 °C. The corrosion rate at the temperature of 180 °C was the lowest. The corrosion rates of the S135 and G105 were 0.2291 mm/y and 0.2309 mm/y, respectively. CO2 was not the main controlling factor in the corrosion. The corrosion product was FeS. High temperatures aggravated the carbon-steel corrosion further in the environment with the high concentration of CO2 and a loose corrosion-product film formed. The dense and uniform FeS corrosives formed and attached to the surface of the substrate, and inhibited corrosion. Dense and uniform FeS products formed on the surface of the steel with the increase in temperature. A small amount of H2S inhibited the progress of the corrosion.

Mechanism and anti-corrosion measures of carbon dioxide corrosion in CCUS: A review

“…However, with the increase of temperature, dense and uniform FeS products are formed on the surface of steel, which can inhibit corrosion. 74

Figure 7 Effect of temperature on corrosion (A) Corrosion rates of S135 and G105. (B) Localized corrosion rate of 20 G steel.

…”

“… Figures reproduced from: (A) (Gao et al. 74 ) Copyright 2022, MDPI; (B) (He et al. 75 ) Copyright 2022, Elsevier; (C and D) (Eškinja et al.…”

Characterization and Analysis of Corrosion Resistance of Rubber Materials for Downhole Tools in a High-Stress Environment with Coupled H2S-CO2

“…To address these issues, a dynamic cyclic multiphase flow high-temperature autoclave capable of reaching maximum pressures and temperatures up to 150 MPa and 350 °C, respectively is employed for simulating actual temperature and pressure conditions at 90 MPa/80 °C and 90 MPa/160 °C as depicted in Figure 3. The high-temperature and high-pressure reactor was developed by Southwest Petroleum University (Model: GF-150-350-6HC) [29].The equipment can simulate the corrosive environment of underground high-temperature and high-pressure fluid flow by heating equipment, blade stirring and gas injection. Compared with the conventional high-temperature and high-pressure reactor, it can simulate the working environment of underground tools more truly.…”

Investigation of the Effect Chloride Ions on Carbon Steel in Closed Environments at Different Temperatures

“…Corrosion in carbon steel alloy is electro conductive media is influenced by the properties of the media in which they are immersed or exposed such as salt concentration [3], humidity [4], dissolved oxygen [5], and temperature [6].…”