Effect of sandpaper roughness and stream turbulence on the laminar layer and its transition

External heat transfer measurements on a highly loaded turbine vane with varying surface roughness are presented. The investigation comprises nine different roughness configurations and a smooth reference surface. The rough surfaces consist of evenly spaced truncated cones with varying height, diameter, and distance, thus covering the full range of roughness Reynolds numbers in the transitionally and fully rough regimes. Measurements for each type of roughness are conducted at several freestream turbulence levels (Tu1=4% to 8.8%) and Reynolds numbers, hereby quantifying their combined effect on heat transfer and laminar-turbulent transition. In complementary studies a trip wire is used on the suction side in order to fix the transition location close to the stagnation point, thereby allowing a deeper insight into the effect of roughness on the turbulent boundary layer. The results presented show a strong influence of roughness on the onset of transition even for the smallest roughness Reynolds numbers. Heat transfer coefficients in the turbulent boundary layer are increased by up to 50% when compared to the smooth reference surface.

show abstract

Effect of Elevated Free-Stream Turbulence on Transitional Flow Heat Transfer Over Dual-Scaled Rough Surfaces

Wang

Rice²

2005

Journal of Heat Transfer

View full text Add to dashboard Cite

The surface roughness over a serviced turbine airfoil is usually multiscaled with varying features that are difficult to be universally characterized. However, it was previously discovered in low free-stream turbulence conditions that the height of larger roughness produces separation and vortex shedding, which trigger early transition and exert a dominant effect on flow pattern and heat transfer. The geometry of the roughness and smaller roughness scales played secondary roles. This paper extends the previous study to elevated turbulence conditions with free-stream turbulence intensity ranging from 0.2% to 6.0%. A simplified test condition on a flat plate is conducted with two discrete regions having different surface roughness. The leading-edge roughness is comprised of a sandpaper strip or a single cylinder. The downstream surface is either smooth or covered with sandpaper of grit sizes ranging from 100 to 40 Ra=37-119 μm. Hot wire measurements are conducted in the boundary layer to study the flow structure. The results of this study verify that the height of the largest-scale roughness triggers an earlier transition even under elevated turbulence conditions and exerts a more dominant effect on flow and heat transfer than does the geometry of the roughness. Heat transfer enhancements of about 30–40%-over the entire test surface are observed. The vortical motion, generated by the backward facing step at the joint of two roughness regions, is believed to significantly increase momentum transport across the boundary layer and bring the elevated turbulence from the freestream towards the wall. No such long-lasting heat transfer phenomenon is observed in low free-stream turbulence cases even though vortex shedding also exists in the low turbulence cases. The heat transfer enhancement decreases, instead of increases, as the downstream roughness height increases.

show abstract

scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.

Contact Info

customersupport@researchsolutions.com

10624 S. Eastern Ave., Ste. A-614

Henderson, NV 89052, USA

Blog Terms and Conditions API Terms Privacy Policy Contact Cookie Preferences Do Not Sell or Share My Personal Information

Made with 💙 for researchers

Part of the Research Solutions Family.

Effect of sandpaper roughness and stream turbulence on the laminar layer and its transition

Cited by 14 publications

References 13 publications

By-pass transition of flat plate boundary layers on the surfaces near the limit of admissible roughness

By-pass transition of flat plate boundary layers on the surfaces near the limit of admissible roughness

Surface Roughness Effects on External Heat Transfer of a HP Turbine Vane

Effect of Elevated Free-Stream Turbulence on Transitional Flow Heat Transfer Over Dual-Scaled Rough Surfaces

Contact Info

Product

Resources

About