Effect of alkaline treatment on mechanical properties of composites: Unsaturated polyester reinforced ZrO₂/jute and sisal

Abstract

Alkali treated (5 wt. % alkali was used on the total weight of the alkali solution and the treatment time was 2 h) discontinuous cellulosic fiber (jute and sisal were used as cellulosic fibers and 35 wt. % filler content was incorporated) reinforced chemically modified ZrO2 (ZrO2 was used as 10 wt. % of total filler content. In this context, it is worthwhile to mention that when both fillers were used, the fiber content was taken in the weight ratio of 1:1.) dispersed hybrid unsaturated polyester composites were fabricated by a compression molding technique. The mechanical behavior of the fabricated composites was evaluated at the sub-micron scale by nanoindentation (indentation with an applied load on the composites surface at the nano-metric range) or depth-sensing instrumented indentation technique. The significant effect of incorporation of the dispersing phases within the unsaturated polyester matrix with respect to mechanical properties at microstructural length scale was observed. A marked improvement in the nanoindentation-derived parameters viz. , nanohardness, reduced modulus, elastic recovery, and indentation creep was observed which may be attributed due to the influence of fillers inclusion within the unsaturated polyester matrix. An extensive effort was laid to analyze the dynamic mechanical properties using the sinus indentation mode associated with nanoindentation measurements to further correlate the influence of fillers addition with the indentation-derived parameters.

Surface Functionalization of Jute Fibers In The Presence Of Sodium Hydroxide and Graphene Oxide in the Preparation of Bio Composite

“…At the 15mm (Fig. 3) fibers length strength of the composites increases [23]. The flexural properties of the treated jute based bio composites increases when the the percentage of jute fibers increase in comparison with untreated jute fibers composites.…”