Dynamic modeling and simulation of impact in hydraulic cylinders

Abstract

In this paper, modeling impact dynamics of a piston and its cylinder body in a hydraulic cylinder is investigated. The studied system consists of two identical hydraulic cylinders controlled by a pressure sequence valve. The impact is assumed as a linear one dimensional and purely translational viscoelastic impact of rigid bodies. Four impact models, the Kelvin-Voigt, the Maxwell, the standard-solid, and the Hunt-Crossley, are considered. Measurements of the transient variations of the cylinders operating pressures and both pistons strokes, at different loading conditions, are conducted. A comprehensive dynamic model of the studied system, considering the four models, is deduced. The Kelvin-Voigt model produced tensile forces by the end of the contact period and it resulted in discontinuities in the contact force during its steady state period. Both results are physically impossible in rigid bodies impacting. In the Maxwell model, large amount of discontinuities appeared in the contact force, which causes the piston to make an infinite number of rebounds during the contact period. In the standard-solid model, the discontinuities in the contact force were found to be much less than those of the Maxwell model. As a result, when the impact occurs, the cylinder pressure gets an overshoot accompanied with large oscillations when the Maxwell model is applied, however, these oscillations do not approximately appear when the standard-solid model is applied. The simulation results showed also that the Hunt-Crossley nonlinear model presented very high penetration depth, which is certainly unrealistic in rigid bodies impacting. The validation of the proposed dynamic models showed that the standard-solid is the most suitable model that may represent the impact in the studied cylinders.

Nonlinear Dynamics of Vibro-Impacting Indenter

“…Transient impacts can also be modelled in different ways, as shown by Gad [1]. They can also excite the natural frequencies of the systems, as demonstrated by Mokhtar et al [2].…”