Double-Input PWM DC/DC Converter for High-/Low-Voltage Sources

Chen, Yaow-Ming; Liu, Yuan-Chuan; Lin, Sheng-Hsien

doi:10.1109/tie.2006.882001

Cited by 222 publications

(88 citation statements)

References 12 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In this proposed system a non-isolated SEPIC converter is used as the PVSC as well as PVLC with the storage device. Since sustainable power sources are irregular in nature, the use of device capacity is necessary for reliability aspects [25]. A classification of the various multiport converters is given in Figure 3.…”

Section: Introductionmentioning

confidence: 99%

Analysis of Non-Isolated Multi-Port Single Ended Primary Inductor Converter for Standalone Applications

Anuradha

Sakthivel²,

Venkatesan³

et al. 2018

Energies

View full text Add to dashboard Cite

Abstract:A non-isolated Multiport Single Ended Primary Inductor Converter (SEPIC) for coordinating photovoltaic sources is developed in this paper. The proposed multiport converter topologies comprise a Single Input Multi yield (SIMO) and Multi Input Multi Output (MIMO). It is having the merits of decreased number of parts and high power density. Steady state analysis verifies the improved situation of both the proposed topologies, which is further checked through simulation results.Keywords: single input multi output; multi input multi output; single ended primary inductor converter

show abstract

Section: Introductionmentioning

confidence: 99%

Analysis of Non-Isolated Multi-Port Single Ended Primary Inductor Converter for Standalone Applications

Anuradha

Sakthivel²,

Venkatesan³

et al. 2018

Energies

View full text Add to dashboard Cite

show abstract

“…The AC power from the vehicle can then be used to power stand-alone loads or can be fed back into the grid. Safety systems similar to those used with small DG systems prevent the vehicle from feeding power into the grid when grid power is not available (Zhang et al, 2011a;Gummi and Ferdowsi, 2010;Benavides and Chapman, 2005;Mummadi and Sawant, 2008;Chen et al, 2003).…”

Section: Pes Topologiesmentioning

confidence: 99%

Power electronics in smart grid distribution power systems: a review

Bayoumi

2016

IJIED

View full text Add to dashboard Cite

Distributed generation (DG) in smart grid (SG) is being employed as a means of achieving increased reliability for electrical power systems as regarded by consumers. As the most of DG technologies utilise renewable sources, the power electronic interface plays a vital role to match the characteristics of a DG unit with the grid requirements. This paper presents the power electronics capabilities required for DG systems in SG to convert the generated power into useful power that can be directly interconnected with the utility grid and/or that can be used for consumer applications. Because of the enhancement and the different power ranges of power electronics devices, the development of advanced power electronic interface that is scalable to meet different power requirements, with modular design, lower cost, and improved reliability, will improve the overall performance and durability of smart grid distributed power systems.

show abstract

“…The proposed multi-input dc-dc converter is the fusion of the buck-boost and the buck converter [17]. Syntheses of the multi-input dc-dc converter are done by inserting the pulsating voltage source of the buck converter into the buck-boost converter.…”

Section: Multi-input Dc-dc Convertermentioning

confidence: 99%

“…Therefore, it is very suitable for renewable energy applications. Details of the circuit operation principle can be found in [17]. if has longer conduction time than has, the sequence becomes Mode II, Mode III, and Mode IV.…”

Section: Multi-input Dc-dc Convertermentioning

confidence: 99%