Direct detection of benzene, toluene, and ethylbenzene at trace levels in ambient air by atmospheric pressure chemical ionization using a handheld mass spectrometer

Abstract

The capabilities of a portable mass spectrometer for real-time monitoring of trace levels of benzene, toluene, and ethylbenzene in air are illustrated. An atmospheric pressure interface was built to implement atmospheric pressure chemical ionization for direct analysis of gas-phase samples on a previously described miniature mass spectrometer (Gao et al. Anal. Chem. 2006, 78, 5994 -6002). Linear dynamic ranges, limits of detection and other analytical figures of merit were evaluated: for benzene, a limit of detection of 0.2 parts-per-billion was achieved for air samples without any sample preconcentration. The corresponding limits of detection for toluene and ethylbenzene were 0.5 parts-per-billion and 0.7 parts-per-billion, respectively. These detection limits are well below the compounds' permissible exposure levels, even in the presence of added complex mixtures of organics at levels exceeding the parts-per-million level. The linear dynamic ranges of benzene, toluene, and ethylbenzene are limited to approximately two orders of magnitude by saturation of the detection electronics. (J Am Soc Mass Spectrom 2010, 21, 132-135)

Adsorption and Desorption of Chemical Warfare Agent Simulants on Silica Surfaces with Hydrophobic Coating

“…[5][6][7] Pre-concentrators can include highly efficient adsorbents for CWAs and heating unit. Increasing temperature of the adsorbents will result in desorption of CWAs adsorbed (or accumulated) on adsorbent surface, which can temporarily increase local concentration of CWAs in the pre-concentration-unit, and enhance the detection limit of detector by many orders of magnitude.…”

A Low-Cost, Simplified Platform of Interchangeable, Ambient Ionization Sources for Rapid, Forensic Evidence Screening on Portable Mass Spectrometric Instrumentation

“…Direct air monitoring and headspace analysis has been demonstrated on portable MS systems by utilizing simplified atmospheric pressure chemical ionization (APCI) sources [60,61], including trace detection of toxic industrial compounds from room air [62,63] and headspace vapors of common solvents utilized in clandestine drug manufacture [19,22,64]. APCI, first reported by Horning et al, commonly employs a corona discharge to create primary reagent ions (typically a series of protonated water clusters, depending on relative humidity) via ion/molecule reactions starting with N 2 +· and O 2 +· [65].…”

A Field-Portable Membrane Introduction Mass Spectrometer for Real-time Quantitation and Spatial Mapping of Atmospheric and Aqueous Contaminants

“…This is especially useful for timely process control decisions, emergency response scenarios, adaptive sampling during field measurement campaigns, and long-term environmental monitoring studies. The presented system is amenable to several improvements including the inclusion of a thermally assisted membrane [33] to improve detection limits for SVOC analytes and the implementation of various chemical ionization methods to improve instrument selectivity [28,30,36]. Future software development will focus on cataloguing data for improved online database access, additional data input features (e.g., real-time dilution calculations), and improved data (and meta-data) presentation for real-time quality control analysis.…”