Development of ultra-compact plastic-packaged high-isolation GaAs SPDT switch

Uda, H.; Hirai, T.; Tominaga, H.; Nogawa, K.; Sawai, Terumitsu; Higashino, Takeshi; Harada, Yasoo

doi:10.1109/96.486501

Cited by 3 publications

(1 citation statement)

References 6 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Effects of the molding compound on the performance of Single Pole Double Throw (SPDT) switches have been studied using Electromagnetic (EM) simulation by Uda et al [1,2] and Xiao et al [3] and method to minimize the performance degradation by parasitic effect modeling has been suggested. Jessie and Larson [4] have discussed the development of a plastic Small Outline (SO) package with remarkable performance in X-band by EM optimization of the package structure and package leads.…”

Section: Introductionmentioning

confidence: 99%

Electromagnetic Simulation and Characterization a Metal Ceramic Package for Packaging of High Isolation Switches

Chaturvedi¹,

Bhalke²,

Saravanan³

et al. 2010

PIER C

View full text Add to dashboard Cite

Abstract-Packaging of planar MMICs poses a unique challenge at microwave frequencies as the dimensions of the encapsulating cavity are comparable to wavelength at the operational frequencies. In addition, the effect of ground loops (caused by bond wires exposed to ground over extended length due to gaps between interconnects) deteriorates the situation even further in circuits like MMIC switches requiring high isolation between ports. The ground loops cause reflections thereby deteriorating the insertion loss figure of merit. This paper presents optimization of design of a metal ceramic package used for packaging an SPDT MMIC switch working in the frequency range of 5-6 GHz. The microwave performance of the package was simulated using EM simulation with parameters including cavity dimensions, port placement, gaps between interconnect lines, package feed-thrus and MMIC chip pads. Detailed characterization of the bare package and packaged SPDT MMIC done later shows a good match between the simulated and measured performance. The SPDT MMIC performance degradation was arrested by improvement in the package structure and it showed insertion loss of −1.6 dB and input/output (I/O) return losses of ∼ 16 dB in the new package as compared to the values of −2.1 dB insertion loss and −12 dB I/O return losses in the original package. The port-to-port isolation remained unchanged (∼ 40 dB in both cases) as it is governed by the MMIC assembly inside the package rather than the conditions at the I/O interfaces in this kind of large sized packages.

show abstract

Section: Introductionmentioning

confidence: 99%