Determination of total nitrogen content in fresh leaves and leaf powder of Dendrobium orchids using near-infrared spectroscopy

Karoojee, Supasuta; Noypitak, Sirinad; Abdullakasim, Supatida

doi:10.1007/s13580-020-00301-2

Cited by 4 publications

(1 citation statement)

References 15 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Many studies now exist on the use of FT-NIR spectroscopy for macro and micronutrient determination in plant leaves with varying levels of success in terms of accuracy 3 , 26 – 28 . Some studies have also compared model results between fresh leaf and powdered leaf spectra, with higher prediction accuracy achieved using powdered leaf 29 , 30 . However, while research on FT-MIR spectroscopy and plant material has recently expanded, there is still a limited application to nutrient prediction models.…”

Section: Introductionmentioning

confidence: 99%

Effects of fine grinding on mid-infrared spectroscopic analysis of plant leaf nutrient content

Whatley

Wijewardane

Bheemanahalli

et al. 2023

Sci Rep

View full text Add to dashboard Cite

Fourier transform mid infrared (FT-MIR) spectroscopy combined with modeling techniques has been studied as a useful tool for multivariate chemical analysis in agricultural research. A drawback of this method is the sample preparation requirement, in which samples must be dried and fine ground for accurate model calibrations. For research involving large sample sets, this may dramatically increase the time and cost of analysis. This study investigates the effect of fine grinding on model performance using leaf tissue from a variety of crop species. Dried leaf samples (N = 300) from various environmental conditions were obtained with data on 11 nutrients measured using chemical methods. The samples were scanned with attenuated total reflectance (ATR) and diffuse reflectance (DRIFT) FT-MIR techniques. Scanning was repeated after fine grinding for 2, 5, and 10 min. The spectra were analyzed for the 11 nutrients using partial least squares regression with a 75%/25% split for calibration and validation and repeated for 50 iterations. All analytes except for boron, iron, and zinc were well-modeled (average R2 > 0.7), with higher R2 values on ATR spectra. The 5 min level of fine grinding was found to be most optimal considering overall model performance and sample preparation time.

show abstract