Design Optimization of an Efficient Bicolor LED Driving System

Abstract

There are some challenges involved in the design of a multicolor LED driver, such as the precise control of color consistency, i.e., maintaining the correlated color temperature (CCT) and luminous intensity. CCT deviation causes a color shift of composite light. This paper approaches the method of nonlinear optimization of the LED currents of two LED sources to achieve the desired CCT. A bicolor blended-shade white LED system is formed by using a warm color LED source of 1000 K CCT and a cool color LED source of 6500 K CCT. By using a nonlinear optimization methodology, the reduced deviation of the blended CCT and optimum LED currents are obtained. The optimized currents in the two LED strings are maintained by the control circuit of the single-ended primary inductor converter (SEPIC). The obtained reduced deviation of the CCT is 43 K, and the precision is 99.15%. Again, harmonics in the input current hamper power quality, i.e., reduce the power factor and increase power loss. This paper proposes the harmonic reduction technique to achieve the lowest value of total harmonic distortion (THD) through the nonlinear parametric optimization of the SEPIC. Measured THD = 4.37%; PF = 0.96; and efficiency = 92.8%. The system stability was determined and found to be satisfactory.

An Influence of Parameters of the Control Signal of Power LEDs on Their Junction Temperature and Emitted Light

“…Papers [23][24][25][26] present a review of the techniques of controlling power LEDs using the rectangular PWM signal controlling the gate of the power transistor, full-bridge and half-bridge systems. The operating characteristics of the current and voltage stabilizer systems with the use of a series resistor to limit the current flowing through the power LED and a classical voltage divider are also mentioned and shown.…”