Design of Automatic Temperature Control System on Laser Diode of Erbium-Doped Fiber Source

Li, Chengxiang; Yu, Zhenhua; Wu, Xu; Li, Feng

doi:10.1109/icicta.2011.113

Cited by 4 publications

(1 citation statement)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…However, this is also one time programming and it is needed to be interfaced with the computer anytime re-programming is needed, hence, the operation of the system becomes complex. Although a number of similar temperature control system, “do-it-yourself” temperature control designs have recently been published [ 5 , 7 , 8 , 9 , 10 , 11 , 12 , 13 , 14 , 15 , 16 ], these designs are not easy to use in term of programming and temperature adjustment. The systems work on the benefits of using temperature adjustable and fan temperature control systems.…”

Section: Related Workmentioning

confidence: 99%

Design and simulation of an automatic room heater control system

Zungeru

Mangwala

Chuma

et al. 2018

Heliyon

View full text Add to dashboard Cite

This paper presents the design and simulation of an Automatic Room Heater Control system. This system allows the user to set a desired temperature which is then compared to the room temperature measured by a temperature sensor. With the help of a microcontroller, the system responds by turning ON any of the two (2) loads (Fan or a heater) automatically depending on the temperature difference. The Fan is triggered ON when the room temperature is higher than the set temperature and the heater is triggered ON when the room temperature is lower than the set temperature. The system was designed and simulated using Proteus 8, circuit building software used for building electronics system. Proteus software was used to design and simulate the main circuit, and Micro-C hex file was loaded on the Proteus schematic design. For coding the PIC Microcontroller, Micro-C compiler was used. A 5 V DC power supply was designed in order to provide a biasing voltage to most of the active devices used in the system design circuit. The DC power supply was designed and simulated using Multisim software. The system was simulated and simulation results were in accordance to the design specifications.

show abstract