Constructal Design Applied to Geometric Shapes Analysis of Wave Energy Converters

Abstract

This paper deals with numerical simulation and the geometrical analysis of an ocean Wave Energy Converter (WEC), which has as the operating principle the Oscillating Water Column (OWC). The goal was to evaluate the geometric shape influence of the OWC chamber in the hydropneumatic power available. Therefore, four geometric shapes were analyzed: i) Rectangle (RT), ii) Trapezium (TP), iii) Inverted Trapezium (TI) and iv) Double Trapezium (DT). For this, the OWC device was subject to a JONSWAP wave spectrum with peak period (TS) equal to 7.5 s and peak wave height (HS) equal to 1.5 m. To do so, Constructal Design was employed varying the Degree Of Freedom (DOF) H1/L (ratio between the height and length of the OWC chamber entrance). The problem constraints were the entrance area and the total area of the OWC chamber that were kept constant. For the numerical solution a Computational Fluid Dynamics (CFD) code, based on the Finite Volume Method (FVM),de0 was used. The multiphase Volume of Fluid (VOF) model was applied to tackle with the water-air interaction. The results indicated that when the Rectangle (RT) geometrical shape was employed an improvement of nearly 99% was achieved.

Study of the Geometry of an Oscillating Water Column Device with Five Chambers Coupled under Regular Waves through the Constructal Design Method

“…It is necessary to divide the prescribed velocity into horizontal and vertical components, respectively, described as a boundary condition [40]:…”