Composites of the cBN–Si3N4 system reinforced by SiCw for turning tools

Osipov, A. S.; Klimczyk, Piotr; Cygan, S.; Мельнийчук, Ю.А.; Petrusha, І. A.; Jaworska, L.

doi:10.3103/s1063457616010019

Cited by 5 publications

(1 citation statement)

References 12 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The addition of 10 vol % of silicon carbide SiC to that composite allowed about 20 % decrease of flank face wear when discontinuous turning of EN 107WCr5 steel. Furthermore, it was determined that the composite containing 87 vol % cBN, 3 vol % Si 3 N 4 , 10 vol % SiC may be recommended as a tool material for this kind of machining [18].…”

Section: Introductionmentioning

confidence: 99%

On the Wear Comparative Analysis of Cutting Tools Made of Composite Materials Based on Polycrystalline Cubic Boron Nitride when Finish Turning of AISI D2 (EN X153CrMoV12) Steel

Ociepa

Jenek

Feldshtein

2018

J. Superhard Mater.

View full text Add to dashboard Cite

On the wear comparative analysis of cutting tools made of composite materials based on polycrystalline cubic boron nitride when finish turning of AISI D2 (EN X153CrMoV12) steelThis study presents the results of research on the condition of low content polycrystalline cubic boron nitride cutting tools (cBN-L) when finish turning of hardened AISI D2 tool steel. The least changes in the condition of wedges throughout the investigated turning feeds were observed for the composite cBN020 whereas the highest wear intensity was found for the composite cBN200. For all researched cutting materials, abrasive wear, as well intense adhesion were observed.

show abstract

Section: Introductionmentioning

confidence: 99%