Comparison of tribological behaviour for Nylon6-Al-Al₂O₃and ABS parts fabricated by fused deposition modelling

Comparison of wear behavior of ABS and ABS composite parts fabricated via fused deposition modelling

“…When material slide against the emery paper, which was pasted on the rotating disk, material start delaminating form the pin and grooves were formed on the surface and the wear was majorly reduced due to presence of abrasive particle in composite material marked in dark black circles. These results are in line with the finding of other researchers (Xu et al, 2010;Zhang et al, 2011;Boparai et al, 2015;Kulkarni et al, 2016). …”

“…were identified. It was also observed that the composite materials prepared with different proportions are more wear resistant, having less friction coefficients and friction force than the commercially used ABS material for FDM components (Boparai et al, 2015).…”

The Use of Composite Materials in 3D Printing

“…We have seen as dielectric materials, widely used in the electronic area, may be 3D printed using Singh et al tried to improve the properties of commercial ABS for FDM components by adding Nylon6-Al-Al 2 O 3 at different proportions of Al and Al 2 O 3 [48]. In particular, the effect of the abrasive surface, the duration of the run and the applied load on friction and the wear behaviour of the different composites in comparison to the commercial ABS filaments have been studied.…”

Avaliação do desgaste de peças produzidas por manufatura aditiva FDM

“…Em relação ao desgaste de peças produzidas por FDM, Boparai et al (2015) mostrou que quando submetidas à desgaste deslizante, peças de compósitos de Nylon6-Al-AlO3, preparadas com diferentes proporções, apresentam maior resistência ao desgaste que peças de ABS.…”