Comparison of sintering behavior and mechanical properties between WC−8Co and WC−8Ni hard materials produced by high-frequency induction heating sintering

Rapid Consolidation of Nanostructured TiCu Compound by High Frequency Induction Heating and Its Mechanical Properties

“…In this regard, the high frequency induction heated sintering method which can make dense materials within 2 min, has been shown to be effective in achieving this goal. 8,9) The purpose of this work was to evaluate the feasibility of producing dense nanocrystalline TiCu compound using induced current activated sintering method in short time. The method was applied to horizontal ball milled Ti+Cu powder and high-energy ball milled TiCu powders.…”

Rapid consolidation of nanostructured Ti from mechanically activated Ti and TiH2 by pulsed-current activated sintering, and the mechanical properties of the product

“…Nanocrystalline powders have recent been developed by the thermochemical and thermomechanical process called the ''spray conversion process'' (SCP), by co-precipitation, and by high-energy milling [6][7][8]. However, the grain size in sintered materials is much larger than that in pre-sintered powders because of fast grain growth during conventional sintering.…”

Properties and Rapid Consolidation of Nanocrystalline TiCo Compounds by High-Frequency Induction Heated Sintering

“…13,14) HFIHS is similar to traditional hot-pressing, but the sample is heated by an induced electric current that flows through the sample and a die. This process increases the heating rate (up to 2000 C/min) to a degree much higher than that of traditional hot-press sintering.…”