Coating hydroxiapatite on stainless steel 316 L by using sago starch as binder with dip-coating method

Fadli, Ahmad; Akbar, Fajril; Prabowo, Agung; Hidayah, Putri Husni

doi:10.1088/1757-899x/345/1/012036

Cited by 6 publications

(3 citation statements)

References 2 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The immersion time was varied between 10 seconds and 20 seconds, which is based on our previous study [13]. The data of the HA layer thickness formed on the 316L stainless steel substrate affected by the immersion time at each slurry composition and sintering temperature can be seen in Figure 5.…”

Section: Sem Analysismentioning

confidence: 99%

“…In this study, the sintering temperature was varied between 700 °C and 800 °C following our previous study [13]. The data of the hydroxyapatite layer thickness formed on the 316L stainless steel substrate affected by the sintering temperature can be seen in Figure 5.…”

Section: Sem Analysismentioning

confidence: 99%

“…In our previous study, hydroxyapatite was successfully coated onto the surface of 316L stainless steel using the dip coating method by varying the stirring time and the starch mass [13]. The coating thickness is an important parameter in the hydroxyapatite coating on a metal surface.…”

Section: Introductionmentioning

confidence: 99%

See 2 more Smart Citations

Empirical Model to Predict the Hydroxyapatite Thickness on the Surface of 316l Stainless Steel by the Dip Coating Method

Fadli¹

2021

Ceramics - Silikaty

View full text Add to dashboard Cite

The surface of 316L stainless steel can be coated with hydroxyapatite to overcome its disadvantages as a medical implant, such as low biocompatibility and the release of toxic metal ions in the body after implantation. The coating thickness is one of the important parameters in the coating process. The use of a model to predict the coating thickness is needed to achieve a standard thickness of the coating. This research aim is to determine the empirical model of the hydroxyapatite coating thickness on the surface of 316L stainless steel by the dip coating method. The HA slurry was made by mixing HA powder, polyethylene glycol, and distilled watere using a magnetic stirrer. The 316L stainless steel substrate were dipped into the slurry and then followed by a drying and sintering process. The empirical model of the HA coating thickness on the surface of the 316L stainless steel in this research is

show abstract

Section: Sem Analysismentioning

confidence: 99%

Section: Sem Analysismentioning

confidence: 99%