Characterization of ultrafine-grained copper joints acquired by rotary friction welding

Abstract

Copper rods with ultrafine-grained microstructure, obtained by multi-turn ECAP processing, were subjected to Direct Drive Rotary Friction Welding using various processing parameters, such as rotational speed and pressure, which resulted in different energy and heat input. Even though friction welding is a high energy process, by a proper selection of processing parameters it was possible to maintain grain size at around 0.7 µm in the weld zone and preserve the UFG microstructure. These microstructural features translated into mechanical properties: the YS for those specimens was around 330 MPa. Processing parameters that resulted in a larger heat input caused an increase in grain size to around 2 µm; this, however, increased ductility and led to a uniform elongation exceeding 5%. Corrosion resistance in the stir zone increased, as was evident in the higher open circuit potential and higher corrosion potential in comparison with base material; the observed differences were about 50 mV. These changes can be explained by the higher fraction of HAGBs in the SZ.