Characterization of Surface Oxide Film Formed on Ti–8Fe–8Ta–4Zr

Abstract

We have already developed a novel -type titanium alloy, Ti-8Fe-8Ta-4Zr, for biomedical applications. Ti-8Fe-8Ta-4Zr showed higher strength than conventional biomedical titanium alloys, such as Ti-6Al-4V ELI, Ti-6Al-7Nb, and Ti-13Nb-13Zr. In addition, the alloy also showed higher corrosion resistance than cp-Ti and Ti-6Al-4V ELI in Hanks' solution. In particular, the breakdown potential of the alloy (the pitting potential) was over 3.5 V vs. SCE (saturated calomel electrode) and much higher than those of cp-Ti and Ti-6Al-4V ELI. A slightly active region was observed at about 1.7 V vs. SCE that may be related to the high breakdown potential.In this study, the surface oxide films on Ti-8Fe-8Ta-4Zr after anodic polarization at 1 and 3 V in Hanks' solution were characterized using X-ray photoelectron spectroscopy and Auger electron spectroscopy to elucidate the high corrosion resistance mechanism of the alloy in Hanks' solution. In addition, the surface oxide film on the alloy before anodic polarization was also characterized for comparison.The surface oxide film on Ti-8Fe-8Ta-4Zr is grown with anodic polarization. Calcium phosphate is formed on the alloy after polarization. The corrosion resistance of the alloy after polarization at a potential above 1.7 V is improved by the concentration of iron and titanium in the surface oxide film. A titanium hyper-oxidized layer with a low iron concentration is observed within the surface oxide film. This layer is generated with polarization and worked as a corrosion-protective layer. The slight active region on the polarization curve may be caused by the dissolution of iron and titanium.

Corrosion Mechanism of Inconel 600 in Oxidizing Supercritical Aqueous Systems Containing Multiple Salts

“…Yin et al and Wu et al reported that the Fe 3+ peak at 711.6 eV was originated from FePO 4 . The binding energy of P 2p was observed to be at 133.3 eV, which can be attributed to the P–O bonding of HPO 4 2– or PO 4 3– . , Therefore, combining with the above-obtained EDS results and XRD patterns, it can be concluded that the corrosion products that covered the alloy surface were mainly NiO, Cr 2 O 3 , NiCr 2 O 4 , Fe 2 O 3 , and phosphates.…”