Este es un artículo publicado en acceso (Open Access) abierto bajo la licencia Creative Commons Attribution NonCommercial, que permite su uso, distribución y reproducción en cualquier medio, sin restricciones siempre que sin fines comerciales y que el trabajo original sea debidamente citado. Resumen: Como objetivo del presente trabajo se persiguió determinar la influencia de la posición relativa de la carga de aleación en los recubrimientos de electrodos, sobre la resistencia al desgaste abrasivo. Para ello, se construyeron especialmente tres electrodos con similar composición química. Las variantes de electrodo construidas se diferenciaron por la posición de la carga de aleación respecto a la posición del recubrimiento ordinario empleado: internas, externas y homogéneas. Se realizan análisis estructurales y de composición química de los depósitos. El ensayo de desgaste aplicado consistió en la determinación de la pérdida de masa y volumen durante el ensayo de pin sobre disco. Se incluye, además, un ensayo de dureza. Del procesamiento de los análisis químicos practicados se obtienen los coeficientes de transferencia de cada uno de los elementos fundamentales de los depósitos. Como resultado se obtuvo que los electrodos con ferroaleaciones externas poseen mayor resistencia al desgaste, teniendo en cuenta las diferencias existentes entre las pérdidas de masa y volumen para las tres variantes de electrodos. Similar comportamiento ocurre con la dureza.Palabras clave: Ensayo de desgaste; Dureza; Depósito de soldadura; Electrodo revestido; Doble recubrimiento.
Wear Resistance Behavior in Deposits Obtained with Simple and Doubly Coated ElectrodesAbstract: The objective of this work was to determine the influence of the relative position of the alloy charge on the electrode coatings on the abrasive wear resistance. For this purpose, three electrodes with similar chemical composition were specially constructed. The electrode variants constructed were differentiated by the position of the alloy charge with respect to the position of the ordinary coating used: internal, external and homogeneous. Structural analyzes and chemical composition of the deposits were carried out. The applied wear test consisted in the determination of the loss of mass and volume during the pin-on-disk test. A hardness test is also included. The coefficients of transfer of each of the fundamental elements of the deposits are obtained from the processing of the chemical analyzes performed. As a result it was obtained that the electrodes with external ferroalloys have greater resistance to wear, taking into account the differences between the losses of mass and volume for the three variants of electrodes. Similar behavior occurs with hardness.
Key-words:Wear test; Hardness; Welding hardfacing; Electrode covered; Double covered electrode.
IntroducciónLos electrodos revestidos se diferencian por el tipo de núcleo o de revestimiento que poseen. Evidentemente, cuando se trata de electrodos con un mismo tipo de núcleo, la única diferencia se deberá al ti...