Behavior of thermally treated kaolin filler in an asphalt concrete mixture

Marín-García, Bryan Felmawer; Quintana, Hugo Alexánder Rondón; Jiménez-Jiménez, Omar Javier

doi:10.22335/rlct.v11i3.861

Cited by 5 publications

(1 citation statement)

References 21 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The results from the two different studies show that the thermal treatment of the waste filler could result in better performance of HMA mixtures. A similar trend was observed when the use of normal kaolin and thermally treated kaolin clay as filler in the HMA mixture was investigated [21]. Samples produced with 100% thermally treated clay were shown to have better performance in terms of Marshall stability and indirect tensile strength (ITS) compared with those of normal kaolin.…”

Section: Introductionsupporting

confidence: 62%

Waste Silt as Filler in Hot Mix Asphalt: A Laboratory Characterization

et al. 2023

View full text Add to dashboard Cite

Several studies aimed to improve both the performance and environmental impact of asphalt pavements using waste and recycled materials as fillers. This study focused on the effect of untreated and thermally treated silt as a filler in hot mix asphalt (HMA). The silt used in the study was a byproduct from a local aggregate production plant in Bologna, Italy. Mineral and chemical analyses revealed that the waste silt required thermal treatment at 750 °C for 2 h. The study compared the use of calcined silt, untreated silt, and a common limestone filler in the production of asphalt mastics and HMA specimens. The rheological properties of the mastics were analyzed using frequency sweep and multiple stress creep recovery tests. The physical and mechanical characteristics of the HMAs were evaluated through the air voids content, Marshall stability and indirect tensile strength tests. Additionally, the water susceptibility and thermal sensitivity of the HMAs were evaluated through the indirect tensile strength ratio and indirect tensile stiffness modulus at different testing temperatures. The results showed that the addition of calcined silt had no significant effect on the rheological properties of the mastic or the optimal binder content. However, the samples produced with thermally treated silt showed the highest stiffness and resistance to rutting compared with the other samples. On the other hand, the addition of untreated silt slightly decreased the stiffness value of the samples. In conclusion, the use of waste silt as a filler has potential as a sustainable and eco-friendly solution for HMAs.

show abstract

Section: Introductionsupporting

confidence: 62%