RESUMOEste trabalho tem como objetivo estudar a melhor região de microemulsão através do cálculo integral da área, mediante a variação de alguns parâmetros. Utilizou--se o óleo de coco saponificado (OCS) tensoativo, butanol (cotensoativo), querosene (componente apolar), água ou salmoura (KCl) (componente polar). As curvas de solubilidade (binodal) foram determinadas utilizando p método de turbidez. A composição da mistura para cada ponto da binodal foi determinada a partir de quantidades tituladas até a turbidez usando balança analítica. Estudou--se a influência da razão cotensoativo/tensoativo (C/T) e a salinidade por meio da variação desses parâmetros. Priorizando a região microemulsionada, verificou--se que para o sistema com água, o aumento da razão C/T amplia a região de microemulsão. O sistema que apresentou melhor área nesse caso foi o água--querosene--butanol/OCS=3. Para um sistema com salmoura, verificou--se que o aumento da salinidade diminuía a região de microemulsão, para uma dada razão C/T fixa. Os sistemas que apresentaram melhor área, nesse caso, foram os sistemas querosene--butanol/OCS=2/2%KCl e querosene--butanol/OCS=3/2%KCl. Analisando a influencia da razão C/T e salinidade juntas, verificou--se que o aumento da razão C/T associado ao aumento da salinidade diminui a região de microemulsão(querosene/butanol/OCS=2--água--2%KCl).PALAVRAS--CHAVE: microemulsão, OCS, querosene, KCl.
INFLUENCE OF REASON C T AND SALINITY IN AQUEOUS PHASE WITH MICROEMULSION SYSTEMS OCS--BUTANOL--WATER--KEROSENE ABSTRACTThis work aims to study the best region of microemulsion by calculating the integral area by varying some parameters. We used a saponified coconut oil (OCS) as surfactant, cosurfactant butanol,kerosene as a nonpolar component, water or brine (2%KCl) as polar component. The binodal curves were determined by clouding point titration method. The composition of the mixture for each point on the binodal curve was determined from the amount of titrant added until turbidity was observed using an analytical balance. We studied the influence of the ratio cosurfactant/surfactant(C/T) and salinity by varying these parameters. Prioritizing the microemulsion region, it was found that for the system with water, the increase of the ratio C/T region extends microemulsion. The system showed the best area in this case was the water--kerosene--butanol/OCS=3. For a system with brine, it was found that increasing the salinity decreased the microemulsion region for a given ratio C/T fixed. The systems that best presented area in this case were the systems kerosene--butanol/OCS=2/2% KCl and kerosene--butanol/OCS=3/2% KCl. For systems in which there was a variation in the salinity and the ratio C/T, it was found that increasing the ratio C/T associated with decreased variation in salinity of the microemulsion region (kerosene--butanol/OCS=2/2% KCl).